:F scan searches on either side of the displayed
memory channel or frequency. The frequency range
searched on either side of the center frequency (mem-
ory channel) is specified by the span.
➀ Push [V/M] to select memory mode or VFO mode,
as desired.
➁ Push [MENU] to select M2.
➂ Push [F1] to select the scan menu.
➃ Push [F4] one or more times to select the desired
span value.
• Selectable span values are ±5 kHz, ±10 kHz, ±20 kHz,
±50 kHz, ±100 kHz, ±500 kHz and ±1 MHz.
➄ In VFO mode, use the keypad or tuning dial to set
the center frequency; in memory mode, rotate [M-
CH] to set the center frequency for memory chan-
nels.
➅ Push [F2] to start/stop :F scan.
• The MHz and kHz decimal points flash during
scan.
• Rotating the tuning dial during scan cancels the
scan.
This is the same as :F scan, except that when a sig-
nal is detected, the scan tuning becomes 10 Hz.
➀ Follow steps ➀ to ➅ above to start :F scan.
➁ During :F scan, push [F3] to toggle between :F
scan and fine :F scan.
➂ Push [F2] to cancel the scan.
■ ABOUT FINE :F SCAN
