12296
82
Zoom out
Zoom in
Previous page
1/88
Next page
18
MAINTENANCE
77
Fuse replacement
If the fuse blows or the transceiver stops functioning, nd the
source of the problem if possible, and replace the damaged
fuse with a new, rated one (FGB 20 A) as shown in the dia-
gram below.
Partial resetting
If you want to initialize the operating conditions without clear-
ing the memory contents, etc., a partial reset function is avail-
able for the transceiver. The partial reset can be performed
independently for each band.
While pushing either left or right, or both [V/MHz] switches,
turn power ON to partially reset the transceiver.
Initialized settings: VFO frequency, SET mode settings.
Retained settings: Memory channels, call channels, offset
freq. in memory/call, DTMF memory,
pager and code squelch settings, initial
SET mode settings.
Resetting the transceiver
The function display may occasionally display erroneous in-
formation, (e.g. when first applying power). This may be
caused externally by static electricity or other factors.
If this problem occurs, turn power OFF. After waiting a few
seconds, turn power ON again. If the problem persists, per-
form the following procedure.
Partial resetting is alternatively available. See previous sec-
tion for details.
Push [POWER] to turn power OFF.
While pushing both left and right [S.MW] switches, turn
power ON.
All LCD segments appear momentarily, the initial display appears
and the transceiver is reset.
CAUTION: Resetting the transceiver CLEARS all
memory information, and initializes all values in the trans-
ceiver.
IC-2710H.qxd 02.2.8 16:55 Page 77 (1,1)
82


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Icom IC-2710H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Icom IC-2710H in the language / languages: English as an attachment in your email.

The manual is 1,38 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info