24
5
REPEATER OPERATION
■ Offset frequency
➀ Select the mode/channel you wish to set the subaudible
tone frequency to, such as VFO mode or memory/call
channel.
• The offset frequency can be individually programmed into each
mode or channel.
➁ Push [SET] one or more times until “DUP” appears and
flashes as shown above.
• Push [MONI] to reverse the order of selection.
• Cancel the DTMF memory encoder function in advance, if nec-
essary. (p. 45)
➂ Rotate the tuning dial to select and set the desired fre-
quency.
• Selectable step increment is the same as the preset tuning step.
(p. 16)
• Use [V/MHz] for quick MHz tuning.
➃ Push [LOW], [TONE], [M/CALL] or [PTT] to exit set mode.
The display shows that a
0.6 MHz (600 kHz) fre-
quency is set.
USING
SET MODE
Ä Set the mode/channel you wish to set the offset
frequency to, such as VFO mode, memory/call
channel or scratch pad memory.
• The offset frequency can be independently pro-
grammed into each mode or channel.
Å Push [FSET] one or more times until “DUP” ap-
pears as shown at left.
• Pushing [GENT] reverses the order of selection.
• Cancel the DTMF memory encoder function in ad-
vance, if necessary. (p. 44)
Ç Push [Y] or [Z] to select and set the desired
frequency.
• Selectable step increment is the same as the preset
tuning step. (p. 16)
• Pushing and holding [Y] or [Z] changes the fre-
quency continuously.
É Push [ECLR] to exit set mode.
☞ NOTE: The offset frequency can be set in a memory chan-
nel temporarily. However, the set contents are cleared
once the memory/call mode is selected. To store the offset
frequency permanently, overwrite the channel information.
