571921
23
Zoom out
Zoom in
Previous page
1/36
Next page
23
fIrIng manualwood
Your first heating session
When you light up for the first time, you must do this very carefully as all materials must be heated
gradually. The door and the ashpan should be opened very carefully as there will otherwise be a risk
that the gaskets will stick to the lacquer. The coating on the stove will be cured the first time the stove
is lit, and this may create an odour. Ensure for adequate ventilation.
D1. Firing (Drawing D)
1. The regulation rod (3) is pushed farthest to the right.
2. The sliding damper (2) in the door and the by-pass damper (1) are opened. Always pull out the
by-pass damper before opening the door.
3. Place 2 firelighters at the bottom of the stove. On top of this, place an amount of split kindling
wood equivalent to two logs (not more than 2 kg). Now light up. Keep door slightly open until
there is no more condensation (approx. 5 – 10 minutes). Shut the door. When the kindling wood
burns well, the regulating rod (3) is placed in middle position. Let the kindlings burn out till there
are no more visible flames.
Important!
Do not open the ash pan when lighting up and always keep it closed when the stove is in use, if not
you can destroy the automatic control.
D2. Continous use
4. When there are no more visible yellow flames, and a right ember is there, you can fire again. A
right ember is when the whole bottom is covered, and the glows are lighting in a ring around the
shaking grate. Add 2 – 3 pieces of firewood (max 2 kg). At first firing, the sliding damper (2) in the
door is regulated down to half open.
5. When there are visible yellow flames again, the regulating rod (3) of the automatic air flow regu-
lating system is pushed back to middle position.
6. When in continuous use, no further regulation is necessary. This is done by the automatic air flow
regulating system giving an even, constant burning. But if you want more heat, the regulating rod
is pushed further to the right, and if you want less heat, the regulating rod is pushed further to
the left. However, you may never close the primary air supply completely. When the stove is cold,
all dampers are closed.
fIrIng In general
Rapid or fierce heat
Rapid or fierce heat is obtained by burning many small pieces of wood.
Maximum amounts of fuel
The stove is approved for a maximum hourly burning of 2,0 kg wood or 1,6 kg briquettes
If these limits are exceeded, the stove will no longer be covered by the factory guarantee, and it may
also become damaged due to excessive heat.
Prolonged burning time
Prolong the burning time by burning a few (at least 2) very large pieces of wood while at the same
time closing the thermostatic control. The burning time can also be prolonged by setting the sliding
damper in the door to half open, though never more than would make the glass pane sooty.
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam Classic 4 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam Classic 4 in the language / languages: English, Danish, Swedish, Norwegian as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam Classic 4

Hwam Classic 4 User Manual - German - 16 pages

Hwam Classic 4 User Manual - Dutch, French, Italian, Spanish - 36 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info