744553
29
Zoom out
Zoom in
Previous page
1/40
Next page
29
Maintenance
Maintenance
Any maintenance of the stove insert should only be carried out when it is cold. Daily maintenance
is limited to a minimum. It is easiest to vacuum-clean the stove insert on the outside using the
small soft brush attachment.
Check that the air gap between the inner frame of the door and the glass is free of ashes and
soot particles. Once a year, the stove insert should be thoroughly serviced. The combustion
chamber should be cleared of ashes and soot. Door and fittings should be lubricated using a
copper-based grease.
Cleaning
After the chimney has been swept, pull the smoke plate forward and upward, then tilt the back
down so that the soot and ashes fall into the combustion chamber. Knock the smoke guide plate
gently so that the rest of the soot and ashes fall off.
For thorough cleaning first remove the steel front of the smoke plate and the two vertical rear
plates. The smoke plate can then be tilted backwards and downwards. Then remove the slanting
rear plates, the bottom plate, the side plates, and finally the slanting front plates. Reassemble
all components in the reverse order.
When removing ashes and soot from the fire chamber, first remove cover plate over the grate of
HWAM Classic 10/60 and take out the ashes or push them into the ash pan.
Ashes
In HWAM Classic 10/60, the ash pan is best emptied by pulling a rubbish bag over the pan, tipping
it and then carefully pulling it out of the bag. In HWAM Classic 10/50, the ashes are shovelled
into a carrier bag. Ashes are disposed of via the domestic rubbish collection.
Please note that there may be embers in the ashes for up to 24 hours after the fire has
gone out!
Insulation
The efficient, but porous insulation of the combustion chamber may, in time, be worn and damaged.
Cracks in the insulation are irrelevant to the efficiency of the stove. However, it should be replaced
when, due to wear and tear, it has been reduced to less than half its original thickness.
Door/glass
Check that the air gaps in the door frame are free of ashes and soot particles.
If the glass is blackened with soot, it can easily be cleaned using steel wool. Carry out frequent
checks to ensure that seals in door and ash pan are intact and not brittle. Failing this, they should
be replaced. Use original seals only.
Surface
Any damage to the lacquer can be repaired with Senotherm spray, which can be bought from
HWAM distributors.
Guarantee
The guarantee does not cover damage due to insufficient maintenance!
29


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam Classic 10-50 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam Classic 10-50 in the language / languages: English, German, Danish, Swedish as an attachment in your email.

The manual is 1,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam Classic 10-50

Hwam Classic 10-50 User Manual - Dutch, French, Italian, Spanish - 40 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info