571925
8
Zoom out
Zoom in
Previous page
1/36
Next page
8
If HWAM 2610/2620 is placed on a flammable floor, always mount it on a plinth whether or not the
floor is covered by a non-flammable material, such as a plate of glass or steel. The plinth is an accessory.
Contact your HWAM dealer for more information.
Drawing A HWAM 2610
HWAM 2630
HWAM 2610
HWAM 2630
1. Recommended for brick wall
10 cm 10 cm
1.
For inflammable back wall
19 cm 19 cm
2.
For inflammable side wall
36 cm 36 cm
1.
To inflammable wall,corner installation
34 cm* 20 cm*
3.
Distance to furnishings in front
80 cm 80 cm
*All dimensions in connection with corner installation are only recommendations. Contact your chimney
sweep for a clarification.
For wall-mounting, HWAM 2610/2620 must be placed at least 3 cm above any inflammable flooring. This
also applies to any floorboard placed on the floor.
Remember to pay attention to any regulations concerning the required distance between
the wall and smoke pipe.
The distance to a brick wall is set to faciliate the servicing of the HWAM Autopilot IHS
TM
. HWAM
2610/2620 may be mounted with wall fittings only on a brick wall. The stove must be taken down when
the HWAM Autopilot IHS
TM
is to be serviced.
Requirements for chimney and smoke pipe
The chimney must be of a sufficient height to enable an adequate draft and to prevent smoke problems.
The stove requires a draft of at least 12 Pa.
The chimney must have a minimum opening equivalent to Ø 150 mm. The chimney opening should always
be at least the size of the outlet socket of the stove. The chimney must have an easily accessible soot door.
Smoke pipe and chimney must always be suitable for a stove connection. Ask your HWAM dealer for
more information.
Changing the smoke outlet from top outlet to rear outlet (drawing F)
1. Lift the cast-iron top (1) off the stove.
2. Remove the rear plate of the stove by loosening the two screws (2).
3. Remove the cover plate (3).
4. Remove the flue ring (4) and fasten it to the rear of the stove.
5. Carefully fold the wires and fasten by pressing the metallic tabs (5).
6. Break off the cut-out (6) in the rear plate and fasten the rear plate to the stove again. Be careful not
to jam the wires when installing the rear plate.
7. Fasten the cover plate (3) to the top of the stove.
8. Place the cast-iron top (1) on the stove.
9. Place the cast-iron top cover (7) in the hole in the cast-iron top plate.
Connection to chimney
All the stoves have both rear and top smoke outlet that can be connected to an approved steel chimney on
top or directly out at the rear to a chimney.
Make sure that the chimney is tight and that no false draft is caused around neither the cover plate, in
connection with a covered smoke outlet, nor the cleanout door and pipe connections. Please note that
bent and/or horizontal smoke pipes will reduce the effect of the chimney draft.
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hwam 2640 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hwam 2640 in the language / languages: English, Italian as an attachment in your email.

The manual is 3,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Hwam 2640

Hwam 2640 User Manual - German, Dutch, French - 52 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info