733969

Husqvarna Z560X Manual

28
Zoom out
Zoom in
Previous page
1/280
Next page
Engine Oil
NOTE: Change the engine oil when the engine
is warm. Refer to the engine owner’s manual
for the correct replacement oil and lter change
recommendations.
1. Park on a level surface. Engage the park
brake.
2. Clean the dirt and debris from the area around
the oil ll cap.
3. Remove the cap/dipstick.
4. Locate the drain hose at the right rear of the
engine below the muer. Put an adequately
sized container under the end of the drain
hose and remove the oil drain plug.
5. Let the oil to fully drain from the engine.
6. Replace the drain hose plug and tighten
securely.
7. Fill the engine with new oil to the bottom of
the ll tube threads. Check the level with the
dipstick.
8. Replace the oil ll cap securely when the oil
level is FULL.
9. Refer to the Service Journal for oil checking
and changing intervals.
Wheel and Deck Zerks
Use only good quality bearing grease. Grease
from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.
Front Wheel Mount
Remove dust cap to expose zerk. Lubricate with
a grease gun until the grease is forced out around
the top washer.
WARNING! The engine drain plug is
located close to the muer. To prevent burns,
the engine should be shut o and allowed to
cool slightly so the engine is still warm but the
surrounding surfaces and oil are not.
Front Wheel Bearings
Lubricate 3-4 strokes with a grease gun on each
set of wheel bearings.
Deck Spindles
10. Lower the cutting deck completely.
11. If a grease gun without rubber hose is used,
the foot plate must be removed to access the
center spindle.
12. Lubricate with a grease gun, 2-3 strokes per
spindle.
Transaxle Fluid Change
Fluid and Filter Change
The hydraulic drive is designed with an external
lter for ease of maintenance. To ensure
constant uid quality levels and longer life, an
oil lter change interval of every 400 hours is
recommended.
Drain old oil lters of all free-owing oil prior
to disposal. Place used oil in appropriate
containers and dispose of it in accordance with
laws in your area.
The following procedure is performed with the
pump installed in the vehicle and the vehicle on
level ground.
1. Park on a level surface. Engage the park
brake.
2. Place an oil drain pan with a 8 quart capacity
beneath the oil reservoir.
3. Remove the oil lter cover and discard the
gasket.
28
LUBRICATION
… 28 …


Need help? Post your question in this forum.

Forumrules
1

Forum

husqvarna-z560x

Reset search

  • What type fluids go in the two containers near the fuel tanks? Submitted on 4-6-2022 at 21:41

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Z560X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Z560X in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 49,58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info