Manual Husqvarna Z560X (page 18 of 280) (English, German, Dutch, French, Italian, Spanish)

733969

Zoom out

Zoom in

1/280

3. Disengage the mower blades by pressing the

blade switch down.

4. Move the steering / park brake controls to the

locked (outer) position.

5. Move throttle control to the middle position. If

the engine is cold, pull the choke control up.

6. Set the fuel tank valve to the desired tank.

7. Set the deck height pin in the desired position.

8. Press in and turn the ignition key to the start

position.

IMPORTANT INFORMATION Do not run the

starter for more than ve seconds each time. If

the engine does not start, wait approximately

ten seconds before retrying.

9. When the engine starts, immediately release

the ignition key back to the run position.

Slowly push in the choke control knob, if it

was used to start a cold engine.

10. Set the engine speed with the throttle. Allow

the engine to run at a moderate speed,

approximately mid throttle, for a short time

before use. USE FULL THROTTLE WHEN

MOWING (no choke).

Running

1. Release the park brake by pulling the steering

/ park brake controls in to the neutral position

at the same time.

NOTE: The mower is equipped with an

operator presence system. If the operator

tries to leave the seat with the engine running,

without rst engaging the park brake, the

engine will shut o.

2. Release deck height control by pushing the

pedal forward to lower the deck to selected

setting.

3. Move throttle control to full throttle.

4. Engage the mower deck by pulling the blade

switch up.

WARNING! Make sure that no one is

near mower when engaging blade switch.

5. Pull control levers inward and slowly move

the two control levers slightly forward to move

forward in a straight line.

Stopping the Engine

1. Move the throttle to the minimum position

(tortoise symbol).

2. Move the steering / park brake controls at the

same time out to the park brake position.

3. Release the mower deck by pressing the

blade switch down.

4. Raise the mower deck by pressing the foot

pedals forward to the transport position.

If the engine has been worked hard, allow it to

idle at least sixty seconds to attain a normal

operating temperature before stopping. To

prevent fouling the spark plugs, avoid idling

the engine for longer periods.

5. Turn the ignition key to the stop position and

remove the key. Always remove the key when

leaving the mower to prevent unauthorized

use.

IMPORTANT INFORMATION When stopping

and leaving the machine, the two steering /

park brake controls must be moved out to the

locked position at the same time.

IMPORTANT INFORMATION Leaving the

ignition switch in a position other than OFF will

cause the battery to be discharged.

Operating on Hills

Read the Safety Instructions Driving on Slopes

in the Safety section.

• Use the slowest speed possible before starting

up or down hills.

• If stopping is fully necessary, pull steering / park

brake controls into the neutral position and push

outward to engage the park brake.

• Pull the steering / park brake controls back to

the center of the mower and push forward to

regain forward movement.

OPERATION

What type fluids go in the two containers near the fuel tanks? Submitted on 4-6-2022 at 21:41
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Z560X in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 49,58 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Husqvarna Z560X Manual

Product: