734150

Husqvarna WDC 225 Manual

10
Zoom out
Zoom in
Previous page
1/368
Next page
•
For Dust Class L products,
WDC 325L, the following
applies:
•
Use the product to clean
dry, non-flammable dust and
liquids, dangerous dusts
with OEL
1)
value > 1mg/m
3
.
Dust Class L (IEC
60335-2-69). The dust with
this class has OEL
1)
values
> 1mg/m
3
.
•
Products with the Dust
Class L, has a tested filter
material. The maximum
degree of permeability is
1%. There is no special
requirement for disposal.
Note: Refer to local laws. They can regulate the age of
the operator.
Safety for double-insulated products
WARNING:
Only use the product as given in
this manual and only with the manufacturer’s
recommended accessories.
WARNING: Only applicable to UK: Read
these important instructions.These
instructions have been prepared with safety
and efficiency paramount. The operator
must be trained by an approved instructor
and must understand these instructions for
operation. The operator must know all the
related regulations and legislation in force at
the time of operation.
WARNING: Before you connect the product:
Make sure that the mains voltage and the
mains frequency of the power supply match
the data on the rating plate of the wet/dry
vacuum cleaner.
WARNING: This product has double
insulation. Use only Husqvarna replacement
parts. See instructions on how to do service
on double-insulated products.
WARNING: The product has a special cord.
If the cord is damaged, it must be replaced
by a cord of the same type. This is available
at approved service centers and dealers and
must be installed by approved personnel.
WARNING: Service on a double-insulated
product requires knowledge of the system.
In a double-insulated products, two systems
of insulation are provided instead of
grounding. No grounding means is provided
on a double-insulated product, nor should a
mean for grounding be added to the
appliance. Service must be done only by
approved service personnel. Replacement
parts for a double-insulated product must be
identical to the parts they replace. A double-
insulated product is marked with the words
“DOUBLE INSULATION” or “DOUBLE
INSULATED.” A symbol may also be used
on the product.
Electrical safety
• It is recommended that the vacuum-cleaner should
be connected via a residual current circuit breaker.
• Arrange the electrical parts (sockets, plugs and
couplings) and lay down the extension lead so that
the protection class is maintained.
• Connectors and couplings of power supply cords
and extension leads must be watertight.
Extension lead
• As an extension lead, only use the version specified
by the manufacturer or one of a higher quality.
• When using an extension lead, check the minimum
cross-sections of the cable:
Cable length
Cross section
< 16 A < 25 A
< 20 m 1.5 mm
2
2.5 mm
2
20-50 m 2.5 mm
2
4.0 mm
2
WARNING: The upper
section of the vacuum-
cleaner contains live
components. Contact with
live components leads to
serious or even fatal
injuries.
10 562 - 004 - 20.03.2019
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna WDC 225 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna WDC 225 in the language / languages: All languages as an attachment in your email.

The manual is 8,86 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info