733952
22
Zoom out
Zoom in
Previous page
1/116
Next page
22
2
Using a ½ inch (13mm) wrench or socket, completely
remove the silver ground screw (1) and set aside.
DO NOT discard, it will be reused later.
On BLACK cable (2), slide protective sleeve (4) back to
expose terminal end (5).
Reinstall previously removed silver ground screw (1)
through exposed terminal end (5) and into location from
where silver ground screw (1) was removed.
Tighten securely. Visually inspect cable to ensure no
part of protective sleeve (4) is trapped under the head of
the ground screw. If needed, loosen silver ground screw,
reposition sleeve and re-tighten screw.
BATTERIE ANSCHLIESSEN
1. Masseschraube (Silber)
2. SCHWARZES Kabel (-)
3. ROTES Kabel (+)
4. Schutzmanschette
5. Polende
WARNUNG: Die Nichtbeachtung der Installationsan-
weisungen kann zu Funkenbildung, Lichtbogen oder
offenen Flammen führen, was zu schweren Körperver-
letzungen oder Sachbeschädigungen führen kann.
WARNUNG: Stellen Sie sicher, dass sich der Zündschalter
des Traktors in der AUS-Position (OFF) befindet und der
Zündschlüssel ABGEZOGEN ist.
Suchen Sie die silberne Masseschraube (1) auf der
rechten Platte des Traktors, über dem rechten Hinterrad.
Suchen Sie das SCHWARZE und ROTE Batteriekabel
im gleichen Bereich. Stellen Sie sicher, dass das ROTE
Kabel (3) am Anlassmagnetschalter angeschlossen
ist, und dass das SCHWARZE Kabel (2) nicht mit der
Schutzmanschette (4) verbunden ist, die das Polende
(5) vollständig bedeckt.
Lösen Sie mit einem ½ Zoll (13mm) Schraubenschlüssel
die silberne Masseschraube (1) vollständig, und legen
Sie diese für später beiseite. NICHT ENTSORGEN, sie
wird später noch benötigt.
Schieben Sie am SCHWARZEN Kabel (2) die Schutzman-
schette (4) zurück, um das Polende (5) frei zu legen.
Setzen Sie die zuvor gelöste silberne Masseschraube (1)
durch das frei liegende Polende (5) an der Stelle ein, an der
Sie zuvor die silberne Masseschraube (1) gelöst hatten.
Fest anziehen. Eine Sichtprüfung des Kabels durchführen,
um sicherzustellen, dass sich kein Teil der Schutzman-
schette (4) unter dem Kopf der Masseschraube verfangen
hat. Lockern Sie bei Bedarf die Masseschraube, setzen Sie
die Manschette korrekt auf und ziehen Sie die Schraube
wieder fest.
CONNECTER LA BATTERIE
1. Vis de mise à la masse (argentée)
2. Câble NOIR (-)
3. Câble ROUGE (+)
4. Manchon de protection
5. Extrémité cosse
AVERTISSEMENT: Le non-respect des instructions
d’installation peut être à l’origine d’une production
d’étincelles, d’arcs électriques ou de flammes nues
susceptibles de provoquer des blessures corporelles
graves ou des dommages matériels.
AVERTISSEMENT: S’assurer que le commutateur d’allu-
mage du tracteur est sur la position d’arrêt (OFF) et que
la clé de contact est RETIRÉE.
4
2
5
1
4
5
1
2
3
CONNECT BATTERY
1. Ground screw (Silver)
2. BLACK Cable (-)
3. RED Cable (+)
4. Protective sleeve
5. Terminal end
WARNING: Not following installation instructions can
result in sparks, arcing or open flames which could lead
to serious personal injury or property damage.
WARNING: Ensure tractor ignition switch is in the OFF
position and ignition key is REMOVED.
Locate silver ground screw (1) on right side plate of tractor,
above right rear tire.
Locate BLACK and RED battery cables in same area.
Ensure RED cable (3) is securely attached to the starter
solenoid and the BLACK cable (2) is not attached with
protective sleeve (4) completely covering terminal end (5).
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna TC 238TX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna TC 238TX in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 11,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info