579242
51
Zoom out
Zoom in
Previous page
1/104
Next page
51
5
SPURGO DELLA TRASMISSIONE
Per assicurare il buon funzionamento prestazionale del trat-
tore, si raccomanda di spurgare la trasmissione prima di met-
tere in funzione il trattore per la prima volta. Ciò consentirà di
eliminare le bollicine d’aria che possono essersi formate nella
trasmissione durante il trasporto.
IMPORTANTE: SE LA TRASMISSIONE E’ STATA SMONTATA
PER RIPARAZIONI O PER LA SOSTITUZIONE, RICOR-
DARSI DI FARE LO SPURGO DOPO LA REINSTALLAZIONE
PRIMA DI RIMETTERE IN FUNZIONE IL TRATTORE.
Parcheggiare il trattore su una superficie piana in modo che
non si metta in movimento in alcuna direzione. La leva del
freno di stazionamento deve essere disinnestata al fine di
eseguire l’operazione seguente.
Disinnestare la trasmissione attivando il comando di ruota
libera.
Avviare il motore e mettere la leva dell’acceleratore sulla
posizione di lento (slow). Accertarsi che il freno di stazion-
amento non sia tirato.
Premere a fondo il pedale di avanzamento, tenerlo premuto
per cinque (5) secondi, quindi rilasciarlo. Premere a fondo il
pedale di retromarcia, tenere premuto per cinque (5) secondi,
quindi rilasciarlo. Ripetere la procedura per tre (3) volte.
Spegnere il trattore girando la chiavetta di avviamento sulla
posizione “OFF”.
Innestare la trasmissione mettendo il comando di ruota
libera sulla posizione di marcia.
Avviare il motore e mettere la leva dell’acceleratore sulla
posizione di lento (slow).
Fare andare avanti il trattore di circa 1,50 metro, quindi
farlo indietreggiare, in retromarcia, della stessa distanza.
Ripetere tre volte questa operazione.
Il trattore è pronto per il normale funzionamento.
TRANSMISSIE ONTLUCHTEN
Voor de juiste werking en prestaties wordt aangeraden om de
transmissie te ontluchten voordat de trekker voor het eerst
wordt gebruikt. Hierdoor wordt lucht binnenin de transmissie
verwijderd, die er tijdens het vervoer van uw trekker kan zijn
ontstaan.
BELANGRIJK: MOCHT UW TRANSMISSIE VOOR ONDER-
HOUD OF VERWISSELING VERWIJDERD MOETEN WOR-
DEN, DAN DIENT HIJ NA DE INSTALLATIE ONTLUCHT TE
WORDEN, VOORDAT U DE TREKKER GEBRUIKT.
Parkeer de trekker veilig op een vlakke ondergrond zodat
hij in geen enkele richting kan wegrollen. Voor de volgende
handeling moet de parkeerrem uitgeschakeld zijn.
Schakel de transmissie uit door de freewheel-hendel in de
free wheel-stand te plaatsen.
Start de motor en breng de gashendel naar de stand
Langzaam. Controleer of de parkeerrem uitgeschakeld zijn.
Druk het vooruitrijpedaal volledig in. Houdt deze vijf (5) sec-
onden ingedrukt en laat dan los. Druk het achteruitrijpedaal
volledig in. Houdt deze vijf (5) seconden ingedrukt en laat
dan los. Herhaal deze procedure drie (3) keer.
Stop de trekker door de contactsleutel naar de stand “OFF
(UIT) te draaien.
Schakel de transmissie in door de freewheel-hendel in de
rijstand te plaatsen.
Start de motor en breng de gashendel naar de stand Lang-
zaam.
Rijd de trekker ongeveer 1 meter 50 vooruit en vervolgens
1 meter 50 achteruit. Herhaal dit drie keer.
Uw trekker is nu klaar voor normaal bedrijf.
51


Need help? Post your question in this forum.

Forumrules
1

Forum

husqvarna-tc-138

Reset search

  • Hi, on my TC 138 there is a slight thumping noise which disappears when I engage the brake. Any ideas please? Submitted on 27-6-2022 at 13:55

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna TC 138 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna TC 138 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info