477694

Husqvarna Sneeuwmachine ST 121E Manual

10
Zoom out
Zoom in
Previous page
1/68
Next page
10
Installing the Handle
1. Remove temporary cable ties (1) holding cables at handle
adjustment holes.
2. Release handle adjustment levers (2) on both sides.
3. Lift operator handle up to the desired height, and close
adjustment lever ensuring the positioning pin (3) on the
lower handle engages one of the three holes (4) on the
upper handle.
4. Pull up and push down slightly on the handle (5) to verify
handle is locked into place.
NOTE: If handle feels unsecure with the adjustment levers
closed, tighten adjustment handle nuts (8) until the handle
feels secure.
5. Remove the cardboard from recoil start handle (6) and
feed the recoil rope through the rope guide (7).
6. Snap two rotator cables (9) and one wiring harness (10)
into the three cable clips (11).
3
9
4
10
11
1
2
7
8
6
5
Ausklappen des Griffs
1. Die provisorischen Kabelschellen (1) entfernen, mit
denen die Kabel an den Einstelllöchern des Handgriffs
befestigt sind.
2. Klinken Sie die Einstellhebel des Handgriffs (2) auf
beiden Seiten aus.
3. Heben Sie den Bediengriff auf die gewünschte Höhe an
und schließen Sie den Einstellhebel so, dass der Stift
(3) auf dem unteren Handgriff in eines der drei Löcher
(4) auf dem oberen Handgriff einrastet.
4. Vergewissern Sie sich, dass der Griff sicher eingerastet
ist, indem Sie leicht am Handgriff ziehen oder diesen
nach unten drücken.
HINWEIS: Sollte der Griff bei geschlossenen Einstellhebeln
nicht fest sitzen, die Stellmuttern (8) so lange festziehen,
bis sich der Griff nicht mehr bewegt.
5. Die Kartonverpackung vom Startergriff (6) entfernen und
das Startseil durch die Seilführung (7) führen.
6. Zwei Kabel der Drehvorrichtung (9) und einen Kabelbaum
(10) in die drei Kabelklemmen (11) einführen.
Dépliage de la poignée
1. Retirez les attache-câbles provisoires (1) maintenant les
câbles au niveau des orifices du réglage de la poignée.
2. Relâchez les leviers (2) de réglage de la poignée des
deux côtés.
3. Levez la poignée à la hauteur désirée et fermez le
levier de réglage en veillant à ce que la goupille de
positionnement (3) de la poignée inférieure soit insérée
dans l'un des orifices (4) de la poignée supérieure.
4. Forcez légèrement sur la poignée (5) pour vérifier que
la poignée est bien enclenchée.
REMARQUE: S'il y a du jeu dans la poignée avec les leviers
de réglage fermés, resserrez les écrous (8) de réglage
jusqu'à ce qu'il n'y ait plus de jeu au niveau de la poignée.
5. Retirez le carton de la poignée du lanceur (6) et achemi-
nez le câble du lanceur à travers la gaine (7).
6. Introduisez deux câbles (9) du rotateur et un câblage
électrique (10) dans les trois attache-câbles (11).
… 10 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Sneeuwmachine ST 121E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Sneeuwmachine ST 121E in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 18,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info