579264
20
Zoom out
Zoom in
Previous page
1/132
Next page
3. Carefully push in the lock mechanism and tilt the
lamp to remove it from the brackets.
4. Put the new lamp in the lower slot on the lamp
housing. Use the type of lamp as given in
Technical
data on page 29
.
5. Press the lamp into the lock mechanism.
6. Put the lower end of the lamp cover into the slots on
the servo housing.
7. Connect the cables to the new lamp.
8. Attach the cover and tighten the screws.
To charge the battery
Charge the battery if it is too weak to start the
engine.
Use a standard battery charger.
CAUTION: Do not use a boost charger
or start booster. That will cause damage
to the electrical system of the product.
Always disconnect the charger before starting the
engine.
To do an emergency start of the
engine
If the battery is too weak to start the engine, you can use
jumper cables to do an emergency start. This product
has a 12 V system with negative ground. The product
that is used for the emergency start must also have a 12
V system with negative ground.
To connect the jumper cables
WARNING:
Risk of explosion because of
explosive gas that comes from the battery.
Do not connect the negative terminal of the
fully charged battery to or near the negative
terminal of the weak battery.
CAUTION: Do not use the battery of your
product to start other vehicles.
1. Remove the engine cover.
2. Remove the cover for the battery case.
20
854 - 003 - 14.11.2018
20


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Rider 213C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Rider 213C in the language / languages: English, Italian, Portuguese, Spanish as an attachment in your email.

The manual is 3,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna Rider 213C

Husqvarna Rider 213C User Manual - German - 132 pages

Husqvarna Rider 213C User Manual - German - 32 pages

Husqvarna Rider 213C User Manual - Dutch - 132 pages

Husqvarna Rider 213C User Manual - Dutch - 36 pages

Husqvarna Rider 213C User Manual - French - 132 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info