Manual Husqvarna Platinum 3000 (page 21 of 34) (English)

517444

Zoom out

Zoom in

1/34

Adjusting the Height of the Hopping Foot

The hopping foot can be adjusted if you are using a thicker batting,

quilting a quilt with thicker seams, or just need a little more clearance.

Note: Adjusting the foot to high may cause poor stitch quality.

1. Lower the needle into the fabric to get the hopping foot to it’s lowest

position. Lowering the needle close to a seam is recommended so

that you can determine the height required to clear the seam.

2. Loosen screw (A) on the side of the hopping foot (B) (g. 23)

3. Move the foot up or down to adjust for your project.

4. Hold the hopping foot where you want it and tighten the screw back down.

To return to the factory setting, place the needle and the foot in the down

position. Place a dime under the foot. Loosen the screw on the side of the

foot and slide the foot down until it rests on top of the dime. Retighten

the screw (g, 24).

Adjusting the Stroke of the Hopping Foot

Factory setting is in the down position.

1. Remove the four (4) screws (A) holding the cover (B) in place front left side of machine

(g, 25).

2. Using a wrench loosen the bolt (C) on the link adjusting crank (D) slide up to increase

the stroke, down to decrease the stroke (g. 26).

3. Use your wrench to tighten the bolt (3).

4. For your safety replace the cover (B) prior to use. Using the four (4) screws (A).

Fig. 23

Fig. 24

Fig. 25

Fig. 26

MACHINE OPERATIONS

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Platinum 3000 in the language / languages: English as an attachment in your email.

The manual is 1,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Husqvarna Platinum 3000 Manual

Product: