518115
18
Zoom out
Zoom in
Previous page
1/32
Next page
16
Sewing
Sewing Buttons
1. Mark the fabric where the button is to be
located.
2. Turn the stitch selector to zigzag
.
3. Lower the feed teeth
. See page 12.
4. Snap off the presser foot.
5. Place the material under the presser foot
ankle.
6. Place the button on marking and lower
the presser bar so that the presser foot
ankle is between the holes of the button
(see picture).
7. Hold the thread ends to one side. Turn
the handwheel and check to be sure that
the needle goes into the holes of the
button.
8. Sew 5-6 stitches. Set the stitch width dial
to 0 and lock the threads with a few stit-
ches.
Use the clearance plate for this purpose. Use
the thin end when sewing buttons on light
fabrics, the thick end for heavier fabrics.
Push in the plate between the button and
the fabric. Lower the presser bar and sew
on the button. Pull the threads between
the button and the fabric. Wind the threads
a few times around the shank and tie the
ends.
Cutting Buttonholes
Cut buttonhole open with the seam ripper.
Place a straight pin across the end you are
cutting toward to avoid cutting too far!
18


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Lena at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Lena in the language / languages: English as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info