Manual Husqvarna LC 551iV (page 21 of 604) (All languages)

733939

Zoom out

Zoom in

1/604

Battery status

The display shows the remaining battery capacity and if

there are problems with the battery. The battery capacity

is shown for 5 seconds after the product is switched off

or the battery indicator button is pressed. The warning

symbol on the battery is on when an error has occurred.

See

Battery on page 24

(Fig. 49)

LED lights Battery status

All LEDs are lit Fully charged (75-100%)

LED 1, LED 2, LED 3 are

lit

The battery is 50%-75%

charged

LED 1, LED 2 are lit The battery is 25%-50%

charged

LED 1 is lit The battery is 0%-25%

charged.

LED 1 flashes The battery is empty.

Charge the battery.

To charge the battery

Charge the battery before the first use. The battery is

only 30% charged when supplied to the customer.

Note: The battery charger must be connected to the

voltage and frequency specified on the rating plate.

The battery does not charge if the battery temperature is

above 50°C. The battery charger decreases the

temperature of the battery before it starts to charge.

1. Connect one end of the power cord for the battery

charger into the socket of the battery charger.

2. Connect the other end of the power cord for the

battery charger in an grounded mains socket. The

LED on the battery charger flashes green one time.

(Fig. 50)

3. Put the battery in the battery charger. The green light

on the charger comes on when the battery is

correctly connected to the battery charger. (Fig. 51)

4. When all LEDs on the battery have come on the

battery is fully charged. Charge the battery for

maximum 24 hours.

5. To disconnect the battery charger from the mains

socket, pull the plug, not the power cord.

6. Remove the battery from the battery charger.

Battery charging status

A Husqvarna Li-ion battery can be charged or used at all

charging levels. The battery is not damaged. A fully

charged battery will not decrease its charge when the

battery is left in the charger.

LED display

Charging status

LED 1 flashes 0%-25%

LED 1 is lit, LED 2 flashes 25%-50%

LED 1, LED 2 are lit, LED

3 flashes

50%-75%

LED 1, LED 2, LED 3 are

lit, LED 4 flashes

75%-100%

LED 1, LED 2, LED 3,

LED 4 are lit

Fully charged

To charge the multi battery

Note: Charge the battery if it is the first time that you use

it. A new battery is only 30% charged.

1. Make sure that the battery is dry.

2. Connect the multi battery to the adapter. (Fig. 52)

3. Put the adapter in the battery charger.

4. Make sure that the green charging LED on the

battery charger comes on. That means that the

adapter and multi battery are connected correctly.

(Fig. 53)

5. When all LEDs on the battery come on and the

adapter shows 100%, the battery is fully charged.

(Fig. 54)

The adapter shows the state of charge in steps of

1%. Small deviations are possible at the start of the

charge.

6. To disconnect the battery charger from the mains

socket, pull the plug. Do not pull the cable.

7. Remove the adapter from the battery charger.

8. Remove the multi battery from the adapter.

Note:

Refer to the multi battery and battery charger

manuals for more information.

To start the product

1. Lift the battery lid.

2. Put a charged battery in battery slot number 1 below

the battery lid. For longer operation time, put a

second charged battery in battery slot number 2.

3. Disconnect the safety key from the safety key holder.

4. Push the safety key into the safety lock. (Fig. 55)

5. Stay behind the product.

6. Push the ON/OFF button on the control panel. The

display comes on.

7. Loosen the start inhibitor. (Fig. 22)

8. Push the motor brake handle in the direction of the

handlebar. (Fig. 56)

1336 - 003 - 17.12.2019

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna LC 551iV in the language / languages: All languages as an attachment in your email.

The manual is 8,28 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Husqvarna LC 551iV Manual

Product: