733939

Husqvarna LC 551iV Manual

19
Zoom out
Zoom in
Previous page
1/604
Next page
sure that children and persons
that are not approved cannot
get access to the product,
battery or battery charger.
Assembly
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.
To install and remove the multi battery
(accessory)
1. Remove the 4 rubber covers and the 4 screws from
the motor cover. (Fig. 23)
2. Put the adapter plate onto the motor cover.
3. Attach the adapter plate with the 4 supplied screws
to a torque of 5-6 Nm. (Fig. 24)
4. Open the battery hatch.
5. Remove the battery in slot 1. (Fig. 25)
6. Remove the seal stop. (Fig. 26)
7. Push the battery adapter into the battery
compartment until you hear a click. (Fig. 27)
8. Put the cord of the battery adapter through the seal
stop hole. Attach the cord with the clip. (Fig. 28)
9. Install the multi battery onto the battery adapter.
10. Connect the multi battery to the battery adapter. (Fig.
29)
11. Attach battery adapter cord to the handle with the 3
fabric straps. (Fig. 30)
12. Remove the multi battery in the opposite sequence.
WARNING:
Do not attach the cord too
loosely to the handle. The cord can come off
the handle and cause injury.
To assemble the handle (LC 551iV)
1. Loosen the lower knobs.
2. Move the knobs to the lower end of the grooves on
the left and the right side of the product. (Fig. 31)
3. Set the handle height in one of the 2 available
positions.
4. Move the knobs up in the direction of the handle until
they stop and you hear a click. (Fig. 32)
5. Tighten the knobs fully.
To assemble the handle (LB 548i)
1. Remove the handle nut and the washer from the
plate on the upper handle.
2. Put the upper handle in position on top of the lower
handle.
CAUTION: Make sure that the wires are
not caught or become damaged.
3. Attach the washer and the handle adjustment lever.
(Fig. 33)
4. Turn the handle to the side for a good operation
position when you operate the product near a wall.
(Fig. 34)
To assemble the grass catcher (LC
551iV)
1. Attach the grass catcher frame to the grass bag with
the rigid part of the bag on the bottom. Keep the
handle of the frame on top of the grass bag. (Fig. 35)
2. Attach the bottom section of the grass catcher frame
in the groove on the bottom of the grass catcher.
3. Attach the grass bag to the grass catcher frame with
the clips. (Fig. 36)
4. Lift the rear cover.
5. Attach the grass catcher to the top edge of the
chassis.
6. Put the lower part of the grass catcher into the grass
discharge channel. (Fig. 37)
To assemble the mulch plug (LC 551iV
accessory)
1. Lift up the rear cover and remove the grass catcher.
2. Put the mulch plug into the discharge channel. (Fig.
38)
3. Replace the blade with the mulch blade that is
supplied with the mulch kit. Refer to
To replace the
blade on page 23
.
1336 - 003 - 17.12.2019
19
… 19 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna LC 551iV at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna LC 551iV in the language / languages: All languages as an attachment in your email.

The manual is 8,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info