Manual Husqvarna LC 141Li (page 20 of 560) (All languages)

733909

Zoom out

Zoom in

1/560

2. Remove the knob, washer, and screw on the left and

the right side.

3. The handle can be set to 2 different heights. Put the

screw in one of the 2 holes on the left and the right

side.(Fig. 37 )

4. Attach the screws, washers and knobs.

5. Move the knobs up in the direction of the handle until

they stop and you hear a click. Tighten the knobs

fully.(Fig. 38 )

To assemble the grass catcher

1. Push the 2 transportation covers out and down.(Fig.

39 )

2. Put the top part of the grass catcher onto the lower

part of the grass catcher. Attach the grass catcher

frame with the clips.(Fig. 40 )

3. Lift the rear cover.

4. Attach the hooks on the grass catcher to the top

edge of the chassis.(Fig. 41 )

To assemble the mulching-kit

1. Lift up the rear cover and remove the grass catcher.

2. Put the mulch plug into the grass discharge channel.

The mulch plug of type A is for LC 141Li and

LC 141C. Type B is for LC 141VLi.(Fig. 42 )

3. Close the rear cover.

4. Replace the blade with the Combi blade, see

remove and replace the blade on page 23

Operation

Introduction

WARNING: Before you operate the product,

you must read and understand the safety

chapter.

To set the product in operation position

If the handle is put in transport and storage position (see

To set the product in transport position on page 25

), do

the procedure that follows to put the handle in operation

position.

1. Lift the handle until the lower handle locks into

operation position.(Fig. 43 )

2. Move the lower knobs up in the direction of the

handle until they stop and you hear a click.(Fig. 44 )

3. Tighten the knobs.

4. Lift the upper handle and tighten the knobs.(Fig. 45 )

To set the cutting height

1. Move the cutting height lever rearward to increase

the cutting height.

2. Move the cutting height lever forward to decrease

the cutting height.(Fig. 46 )

CAUTION: Do not set the cutting height too

low. The blades can hit the ground if the

surface of the lawn is not level.

Battery

WARNING:

Before you use the battery, you

must read and understand the safety

chapter. You must also read and understand

the operator's manual for the battery and the

battery charger.

Battery status

The display shows the remaining battery capacity and if

there are problems with the battery. The battery capacity

is shown for 5 seconds after the product is switched off

or the battery indicator button is pressed. The warning

symbol on the battery is on when an error has occurred.

See

Battery on page 24

(Fig. 47 )

LED lights Battery status

All LEDs are lit Fully charged (75-100%)

LED 1, LED 2, LED 3 are

lit

The battery is 50%-75%

charged

LED 1, LED 2 are lit The battery is 25%-50%

charged

LED 1 is lit The battery is 0%-25%

charged.

LED 1 flashes The battery is empty.

Charge the battery.

To charge the battery

Charge the battery before the first use. The battery is

only 30% charged when supplied to the customer.

Note: The battery charger must be connected to the

voltage and frequency specified on the rating plate.

The battery does not charge if the battery temperature is

above 50°C. The battery charger decreases the

temperature of the battery before it starts to charge.

1. Connect one end of the power cord for the battery

charger into the socket of the battery charger.

71 - 005 - 18.05.2018

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna LC 141Li in the language / languages: All languages as an attachment in your email.

The manual is 6,22 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Husqvarna LC 141Li Manual

Product: