733907
24
Zoom out
Zoom in
Previous page
1/560
Next page
Troubleshooting
Battery
LED on the battery Possible faults Possible procedure
The green LED is flash-
ing
The battery voltage is low Charge the battery. See
To charge the battery on
page 20
.
The error LED flashes The battery is weak Charge the battery. See
To charge the battery on
page 20
.
The temperature in the work environ-
ment is too high or too low
Use the battery in temperatures between -10°C
and 40°C.
Overvoltage Check that the mains voltage is the same as on
the rating plate on the product.
Remove the battery from the battery charger. Wait
5 seconds and try again to charge the battery. If
the problem continues, speak to an authorised
service agent.
The error LED is on Cell difference too much (1V) Speak to an approved service agent.
Battery charger
LED on the battery
charger
Possible faults Possible procedure
The error LED flash-
es
The temperature in the work en-
vironment is too high or too low
Use the battery charger in temperatures between 5°C
and 40°C.
The error LED is on Speak to an approved service agent
Control panel
For problems, other than those in this section, speak to
your service agent.
Keypad Possible faults Possible action
Error LED flashes The motor is overloaded Increase the cutting height. See
To set the cutting
height on page 20
.
The motor speed drops too much,
and the motor stops
The motor control is too hot Stop the motor and wait until it has become cool
The blade is blocked To prevent accidental start turn the safety key to
0, remove the battery and wait a minimum 5 sec-
onds. Make sure that the blade can rotate freely. If
the problem continues, speak to an authorised
service agent
Battery error or no signal from battery Put the battery in the product correctly and exam-
ine the battery connector. If the error LED on the
battery flashes, see
Battery on page 24
.
The product stops The battery is weak Charge the battery. See
To charge the battery on
page 20
.
Battery connector failure Examine the battery connector
24 71 - 005 - 18.05.2018
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna LC 141C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna LC 141C in the language / languages: All languages as an attachment in your email.

The manual is 6,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info