517448
36
Zoom out
Zoom in
Previous page
1/64
Next page
34
THREE-THREAD OVERLOCK WITH ONE NEEDLE
By threading the LEFT needle only, a seam allowance width of 0.24 inches (6 mm) will be
produced. By threading the RIGHT needle only, a seam allowance width of 0.15 inches
(3.8mm) will be produced.
Please remove the unused needle and place it in the needle pad as illustrated.
CONVERTING TO TWO-THREAD USE
To convert to two thread use, rst open the front cover and working table and raise needle
to its highest point by turning hand wheel towards you. Remove the right needle and use
the left needle.
Please remove the unused needle and place it in the needle pad.
Pull out the two-thread converter as showing in Fig. 1.
Attach the two-thread converter onto the upper looper as shown in Figures 2 and 3.
Make sure that you slide the tail end in rst, then put the hook end into the upper looper
hole.
When not using the converter, insert it into the storage pad as illustrated in Fig. 4.
Illustration
*I: Two-thread converter
*II: Upper looper
HClass_200s_EN.indd 34 2010-11-19 09:20:45
36


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna H-Class 200S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna H-Class 200S in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,92 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info