517458
113
Zoom out
Zoom in
Previous page
1/134
Next page
8:11
Embroidery Stitch-Out
Embroidery Stitch-Out pop-up
messages
Embroidery unit calibration
When the embroidery unit is attached, a pop-up message
asks you to slide off the hoop and clear the machine
area for calibrating the embroidery arm. You will also be
reminded to snap on the embroidery presser foot R.
Note: It is very important to remove the hoop, otherwise the hoop or
the embroidery unit may be damaged while calibrating.
Attach correct hoop
If the size of the hoop attached to the machine does not
match the size displayed on screen, the machine will not
embroider. You must change the hoop to the displayed
size or change the hoop setting to match the hoop size
attached.
The hoop needs to be inserted properly for the machine
to detect it. Slide the hoop connector into the hoop
attachment from front to back until it clicks into place.
You will not be able to go to Embroidery Stitch-Out
without the selected hoop attached properly.
Bobbin empty
When the bobbin is almost empty, the machine stops
automatically and a pop-up message appears on the screen.
Note: It is possible to embroider until the thread has completely run
out. Press the Start/Stop button to continue embroidering without
closing the bobbin empty pop-up message.
Close the pop-up message. Replace the empty bobbin
with a full one and pull back excess needle thread. Start
embroidering again by pressing the Start/Stop button or
the foot control.
Note: Use Bobbin Position to get easier access to the bobbin. When
the bobbin is replaced, touch Current Stitch Position to move the hoop
back to where the embroidery stopped.
Check needle thread
The machine stops automatically if the needle thread runs
out or breaks. Re-thread the needle thread, close the pop-
up message, go back a few stitches using the Step Stitch-by-
Stitch control and start embroidering again.
113


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna Designer Diamond at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna Designer Diamond in the language / languages: English as an attachment in your email.

The manual is 10,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna Designer Diamond

Husqvarna Designer Diamond User Manual - German - 134 pages

Husqvarna Designer Diamond User Manual - Dutch - 134 pages

Husqvarna Designer Diamond User Manual - French - 134 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info