477581
22
Zoom out
Zoom in
Previous page
1/96
Next page
22
0
2591
WARNING: Positive terminal must be con nect ed first to
prevent sparks from ac ci den tal grounding.
Remove terminal caps and discard. Connect the red cable to
+ and then the black earth ca ble to -. Screw tight the cables.
Grease the battery poles with vaseline to prevent corrosion.
Replace battery cover.
WARNUNG! Um einen Kurzschluß zu vermeiden, muß der
Pluspol zuerst angeschlossen werden.
Die Schutzkappen von den Anschlußklemmen entfernen und
entsorgen. Die Batterie in Position neben den Fahrersitz brin-
gen. Die Batterieklemmen müssen nach vorn zeigen. Zuerst
das rote Kabel an „+“ und dann das schwarze Kabel an„-“
anschließen. Die kabel fest anschrauben. Batterieklemmen
mit wasserfreiem Fett (Vaseline) einfetten, um Korrosion zu
verhindern. Batterieabdeckung wieder montieren.
ATTENTION : La borne positive doit être connectée la pre-
mière afin d'éviter les étincelles qui peuvent se produire à
la suite d'une mise à la masse accidentelle.
Retirer les capuchons de protection des bornes et les mettre
de côté. Placer la batterie dans son logement, les bornes du
côté extérieur. Raccorder en premier le câble rouge (+) à la
borne positive de la batterie puis le câble noir (-) à la borne
négative. Fixer les deux câbles à l'aide des vis et des écrous
fournis. Graisser les bornes de la batterie avec une graisse
résistante à l'humidité (vaseline) afin d'éviter la corrosion.
Replacer le capotage de la batterie.
ADVERTENCIA: A fin de evitar chispas por contacto acci-
dental a tierra hay que conectar primero el borne positivo.
Remueva las tapas protectoras de los terminales y póngalas
de lado. Ponga la batería en su sitio debajo del asiento. ‘Los
bornes han de estar orientados hacia adelante. Conecte
primero el cable rojo al borne positivo y después el negro
de masa al borne negativo. Sujete los cables. Lubrique los
bornes con grasa que no contenga agua (vaselina) a fin
de evitar la corrosión. Reponga el tapador del acumulador.
PERICOLO: Il polo positivo deve essere collegato per primo
onde evitare scintille.
Togliere i cappucci protettivi dai poli e scartarli.Montare la
batteria nel vano sotto il sedile, con i poli in avanti. Collegare
il cavo rosso al polo positivo (+) e quello nero negativo (-)
alla terra. Ingrassare i poli con grasso privo di acqua (va-
sellina) per evitare corrosione. Rimetter il coperchiodellíac-
cumulatore.
WAARSCHUWING: De positieve klem moet eerst
aangesloten worden om vonken door per ongeluk aarden
te voorkomen.
Verwijder de beschermdoppen van de accupolen en gooi ze
weg. Zet de accu op zijn plaats onder de zitting. De accupolen
dienen naar voren te zijn gericht. Sluit eerst de rode kabel aan
op + en daarna de zwarte aard-kabel op-. Schroef de kabels
vast. Smeer de accupolen in met watervrij vet (vaseline) om
corrosie te voorkomen. Plaats het accudeksel terug.
2
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna CTH182T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna CTH182T in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 3,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info