585401
57
Zoom out
Zoom in
Previous page
1/84
Next page
57
55
55
5
NL
Eng
F
Esp
Switching off the engine
Move the gas control to . Disconnect the cutting unit by
moving the connect/disconnect lever downwards. Lift up the
cutting unit and turn the ignition key to OFF position. Allow
the engine to idle for 1-2 minutes to cool down before
switching off after a hard work.
Abstellen des Motors
Gashebel nach unten auf führen. Mähaggregat durch
Abwärtsführen des Aggregatschalthebels auskuppeln.
Mähaggregat anheben und den Zündschlüssel auf OFF
drehen. Den Motor 1-2 Minuten im Leerlauf arbeiten lassen,
damit dieser nach längerem Mähbetrieb abkühlen kann.
Arrêt du moteur
Amener la comande de gaz en position (ralenti), vers le bas
. Débrayer les lames, Relever le carter de coupe,
Laisser le moteur tourner au ralenti pendant 1 à 2 minutes
pour qu'il refroidisse avant de l'arrêter aprés un travail
pénible, puis tourner la clef de contact en position (off).
Parada del motor
Lleve el acelerador hacia abajo hasta la posición .
Desacople el equipo de corte llevando hacia abajo la palanca
de acoplamiento/desacoplamiento. Levante el equipo de
corte y ponga la llave de encendido en la posición OFF
(apagado). Deje funcionar el motor en ralentí 1-2 minutos
para que se enfríe antes de pararlo después de un tiempo de
uso intenso.
Arresto del motore
Portare il comando del gas su (lento). Portare la leva
di azionamento del dispositivo di taglio su disinserito, verso
il basso. Sollevare il tagliaerba e girare la chiave su off. Far
girare un paio di minuti il motore al minimo per raffreddarlo
prima di spengerlo definitivamente dopo un pesante turno di
lavoro.
Het stoppen van de motor
Breng de gashendel naar beneden tot stand . Schakel
de maaikast uit, door de aan/uitschakelhendel naar beneden
te brengen. Verhoog de maaikast en zet de contactsleutel in
positie OFF. Laat de motor 1-2 minuten stationair lopen om
af te koelen, voordat deze uitgezet wordt.
WARNING!
Do not leave the ignition key in the machine when not in use
to prevent children and other unauthorized persons starting
the engine.
WARNUNG!
Den Zündschlüssel niemals im Zündschloß sitzen lassen,
wenn die Machine unbeaufsichtigt verlassen wird, damit
nicht Kinder und unbefugte Personen den Motor anlassen
können.
ATTENTION!
Ne jamais laisser la clé de contact sur la machine loresqu'elle
reste sans surveillance afin d'éviter que des enfants ou
autres personnes non autorisées ne puissent démarrer
l'outil.
ADVERTENCIA!
Nunca deje la llave de encendido en la máquina sin vigilancia,
a fin de evitar aue niños u otras personas ajenas puedan
arrancar el motor.
ATTENZIONE!
Prima di lasciare la macchina, togliere sempre la chiave.
WAARSCHUWING!
Laat nooit de contactsleutel er in zitten, wanneer de ma-
chine onbemand wordt achtergelaten, om te voorkomen dat
kinderen en onbevoegden de motor starten.
NL
Eng
F
Esp
Downloaded from www.Manualslib.com manuals search engine
57


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna CTH160 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna CTH160 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 2,44 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info