3.7.3 To attach the cutting deck
1. Set the drive unit to OFF. Refer to
To set the
product to OFF on page 31
.
2. Put the cutting deck in front of the drive unit.
3. Open the hatch on the drive unit.
4. Remove the center top cover on the cutting deck.
5. Put the frame on the drive unit above the cutting
deck and the cable.
6. Align the shaft with the hole in the drive unit.
7. Align the shaft with the hole in the frame.
8. Install the screw with the ratchet wrench or torque
wrench, 10 mm. Tightening torque 5 Nm.
9. Tighten the nut on the other side with a 19 mm
open end socket wrench. Tightening torque 9 Nm.
10. Connect the cable to the drive unit. Make sure that
the connection is aligned correctly.
11. Tighten the inner part of the connector clockwise.
12. Lift the rear part of the cutting deck and tilt the
lever.
13. Install the center top cover on the cutting deck.
14. Close the hatch.
1691 - 007 - 22.12.2023 Installation - 19
