6.5 Indicator lamp in the charging
station
For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing
green light. If something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause Action
Green solid light
Good signals. No action required.
Green flashing
light
The signals are good and
ECO mode
is
activated.
No action required.
Blue flashing light
The boundary loop is not connected to
the charging station.
Check that the boundary wire connec-
tors are fitted properly to the charging
station.
Break in the boundary loop. Find out where the break is. Replace
the damaged section of the loop with a
new loop wire, and splice using an orig-
inal coupler.
Red flashing light
Interruption in the charging station’s an-
tenna.
Contact your local Husqvarna repre-
sentative.
Red solid light
Fault in the circuit board or incorrect
power supply in the charging station.
The fault should be rectified by an au-
thorized service technician.
Contact your local Husqvarna repre-
sentative.
1404 - 001 - Troubleshooting - 55
