477691

Husqvarna 125BVx Manual

11
Zoom out
Zoom in
Previous page
1/320
Next page
• Mixture ratio 50:1 (2%)
Gasoline Oil
1 U.S. Gal. 77 ml (2,6 oz)
1 UK Gal. 95 ml (3,2 oz)
5 l 100 ml (3,4 oz)
To make the fuel mixture
Note: Always use a clean fuel container when you mix
the fuel.
Note: Do not make more than 30 days quantity of fuel
mixture.
1. Add half of the gasoline quantity.
2. Add the full quantity of oil.
3. Shake the fuel mixture to mix the contents.
4. Add the remaining gasoline quantity.
5. Shake the fuel mixture to mix the contents.
6. Fill the fuel tank.
To add fuel
• Always use a fuel container with an antispill valve.
• If there is some fuel on the container, remove the
unwanted fuel and let the container dry.
• Make sure that the area near the fuel tank cap is
clean.
• Shake the fuel container before you add the fuel
mixture to the fuel tank.
To start and stop
Before you start the engine
• Examine the product for missing, damaged, loose or
worn parts.
• Examine the collection bag. Make sure that the
collection bag is not damaged and that the zipper is
closed.
• Examine the nuts, screws and bolts.
• Examine the air filter.
• Examine the throttle trigger for correct operation.
• Examine the stop switch for correct operation.
• Examine the product for fuel leaks.
To start a cold engine
WARNING: Do not wind the starter rope
around your arm.
CAUTION: Do not hold the product with your
foot.
CAUTION: Do not pull the starter rope to the
end position. Do not let go of the starter rope
handle when the starter rope is extended.
This can damage the product.
Note: If the engine stops, move the choke control to the
closed position and do the starting steps again.
1. Fill the fuel tank with a clean fuel mixture.
2. Push the primer bulb 10 times. (Fig. 24)
3. Move the engine choke control to the FULL CHOKE
(closed) position. (Fig. 25)
4. Push the variable speed control fully
counterclockwise. (Fig. 26)
5. Use your left hand to hold the body of the machine
on the ground.
6. Pull the starter rope handle until the engine tries to
run. Do not pull more than 3 times.
7. Move the choke control to the 1/2 position and pull
the starter rope handle until the engine starts and
runs. (Fig. 27)
8. Run the engine for approximately 10 seconds.
9. Push and hold the throttle trigger fully through all
remaining steps.
10. Move the choke control to the OFF CHOKE
(opened) position. (Fig. 28)
11. Warm the engine up for 1 minute.
To start a warm engine
1. Push and hold the throttle trigger.
2. Move the choke control to 1/2 position.
3. Pull the starter rope handle quickly while you pull the
throttle trigger until the engine runs.
4. Move the choke control to the OFF CHOKE
(opened) position.
To stop the engine
• Push and release the engine STOP switch. The
switch automatically returns to the ON position. Wait
7 seconds before you try to restart the product to
make sure that the switch resets.
To use a nozzle
• Use the standard nozzle when precision and high air
stream concentration is necessary. (Fig. 29)
• Use the high velocity nozzle when a wider airstream
and large air velocity is necessary. (Fig. 30)
237 - 009 - 16.12.2019
11
… 11 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna 125BVx at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna 125BVx in the language / languages: English as an attachment in your email.

The manual is 6,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Husqvarna 125BVx

Husqvarna 125BVx User Manual - German, Dutch, French - 23 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info