522298
23
Zoom out
Zoom in
Previous page
1/52
Next page
3. Place the escutcheon plate over the
cable hole and use it as a guide to
mark the two escutcheon plate
mounting holes. Remove the plate, drill
two 9/64" diameter x 5/8" deep holes,
and then fill both holes with
marine-grade silicone sealant. Place the
escutcheon plate over the cable hole and
attach with two #8 x 5/8" wood screws.
Hand tighten only!
4. Route and secure the cable by attaching
the cable clamp to the transom; drill one
9/64" diameter x 5/8" deep hole, then fill
hole with marine-grade silicone sealant,
then attach the cable clamp using a
#8 x 5/8" screw. Hand tighten only!
NOTE: If there is excess cable that needs to be
gathered at one location (as shown in the
illustration), dress the cable routed from both
directions so that a single loop is left extending
from the storage location. Doubling the cable up
from this point, form the cable into a coil. Storing
excess cable using this method can reduce
electronic interference (Figure 26).
5. Plug the cable connector back into the
control head. The slots are keyed to prevent
reverse installation, so be careful not to force
the connector into the holder.
Your control head is now ready for operation.
Routing the Cable
Figure 25
Storing Excess Cable
Figure 26
17
Transom Transducer Installation
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Humminbird PiranhaMax 170 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Humminbird PiranhaMax 170 in the language / languages: English as an attachment in your email.

The manual is 1,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info