522298
21
Zoom out
Zoom in
Previous page
1/52
Next page
6. Adjust the transducer assembly vertically,
until the seam on the leading edge of the
transducer (the edge closest to the transom
of the boat) is level and just slightly below
the hull (Figure 23).
NOTE: The transducer has a natural downward slant
of 4-5 degrees from leading edge (closest to the boat
transom) to trailing edge (farthest away from the
boat). Looking at the back of the transducer, the
seam should be slightly below the bottom of the hull.
7. Continue to adjust until the bracket is also
level from port to starboard (horizontally
level as you look at the transducer from
behind the boat (Figure 24).
8. Mark the correct position on the transom by
tracing the silhouette of the transducer
mounting bracket with a pencil or marker.
9. Tighten the pivot bolt, using the pivot screw
and nut to lock the assembly. Hand tighten
only!
10. Hand-tighten the two mounting screws.
NOTE: You will drill the third mounting hole and
finalize the installation after you route the cable and
test and finish the installation in the following
procedures.
Adjusting the Transducer
Mounting Position
Seam aligned with boat hull
Figure 23
Leveling the Mounting
Assembly Horizontally
Level
Level
Figure 24
15
Transom Transducer Installation
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Humminbird PiranhaMax 170 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Humminbird PiranhaMax 170 in the language / languages: English as an attachment in your email.

The manual is 1,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info