AL 600plus 19
6. QUICK INTRODUCTION
(FOR EXPERIENCED USERS)
OPERATION OF THE DEVICE
Connection to 230 V mains:
First connect the battery charger with the 230 V electricity mains (socket). The
green „Mains“
(Netz) LED lights up.
Set battery voltage:
Set the slide switch to 2 V, 6 V and/or 12 V depending on the battery you want
to charge.
Connecting to the battery:
Connect the red connecting terminal of the battery charger to the positive ter-
minal (+) of the battery and the black terminal to the negative pole (–) of the
battery. The battery
can thereby remain connected in the car/motorcycle (see
note N3).
Charging procedure
The device starts the charging procedure automatically. The „Charging“
(Laden)
LED indicates this.
Finished
The battery charger switches the „Finished“ (Fertig) LED on (see note N3) and
goes into the refresh mode, if all test criteria have been fulfilled after charging
and the battery has been evaluated as „Good“. The „Charging“
(Laden) LED
extinguishes simultaneously and the „Refresh“ LED is displayed. The battery is
therefore charged and ready for use and can be disconnected from the battery
charger.
– Finally, pull the mains cable out of the socket. Always pull the plug and never
the cable!
– Check the acid level in non-maintenancefree lead batteries.
– Fill with distilled water, if the acid level is too low.
– Observe the battery manufacturer‘s operating instructions.
