214353
32
Zoom out
Zoom in
Previous page
1/42
Next page
32
Changing the lamp module
Your projector will monitor the lamp’s elapsed operating time, or “lamp
hours.” After 1000 lamp hours, the projector will display the following
message at start-up:
“The lamp has been in use for over 1000 hours.
You may consider purchasing a spare bulb.”
After 1500 lamp hours, the projector will display the following message at
start-up:
“The lamp has been in use for over 1500 hours.
You should purchase a spare bulb.”
NOTE:
The projector’s bulb contains mercury. It may require special handling
at end-of-life.
Procedure:
1. If the projector has been in use -
• Turn the power OFF by pressing the Power ON/OFF button.
• Allow the projector to cool down for at least 30 minutes.
• Disconnect the power cord.
2. Use screwdriver to remove the two screws from the cover.n
3. Remove the cover.o
4. xb31: Remove the two screws from the lamp module.p
sb21: Remove the three screws from the lamp module.p
5. Use the lamp module’s hinged handle to remove the lamp module.q
Reverse these steps to install the replacement lamp module.q
6. Insure that the lamp module door is securely attached and flush with the
unit. The unit will not operate with the door incorrectly installed.
7. Reset the “Lamp Hour” monitor from the On Screen Display (OSD)
“Management” menu tab (refer to page 26).
NOTE:
If lamp module door is not securely fastened the lamp will not
function.
appendices
x
b31 sb21
CAUTION!
AVOID BURN HAZARD.
The lamp gets hot during
normal operation. Allow it to
cool down for 30 minutes
before changing lamp!
CAUTION!
CUT HAZARD.
If the bulb is broken, use
caution to avoid injury.
WARNING!
MERCURY HAZARD. This
projector’s bulb contains a
small amount of mercury. If
the lamp breaks,
adequately ventilate the
area where the breakage
occurred. The projector
bulb may require special
handling and disposal at
end-of-life.
32


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP sb 21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP sb 21 in the language / languages: English as an attachment in your email.

The manual is 7,89 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info