472677
212
Zoom out
Zoom in
Previous page
1/241
Next page
5 Close the print-carriage access door and wait a few minutes for the print carriage to move
back to its home position (on the right side).
Note Make sure the scanner has returned to its parked position before turning off the
HP all-in-one.
6 Press the On button to turn off the HP all-in-one.
7 Unplug the power cord, and then disconnect it from the HP all-in-one. Do not return the
power cord with the HP all-in-one.
Warning The replacement HP all-in-one will not be shipped with a power cord.
Store the power cord in a safe place until the replacement HP all-in-one arrives.
8 See Remove the control panel overlay and pack your HP all-in-one to complete preparation
for shipment.
Remove print cartridges from a nonfunctional HP all-in-one
Follow these steps if you need to remove print cartridges for shipment and your HP all-in-one will
not turn on. See Remove print cartridges from a functional HP all-in-one if your device is turning
on. Follow the steps below to unlock the print cartridge cradle, remove the print cartridges, and
then lock the print cartridge cradle.
1 Unplug the power cord, and then disconnect it from the HP all-in-one. Do not return the
power cord with the HP all-in-one.
Warning The replacement HP all-in-one will not be shipped with a power cord.
Store the power cord in a safe place until the replacement HP all-in-one arrives.
2 Facing the front of the HP all-in-one, turn the right-hand side toward you until approximately
12.5 cm (5 inches) of the bottom right side hangs over the edge of a flat surface (such as a
desk or table).
This exposes a round purple cover on the bottom.
Warning Do not tilt the HP all-in-one on its side, this might cause more damage.
3 Locate the cover on the bottom, and then follow the steps below to unlock the print cartridge
cradle.
a Use the tab to rotate the cover 1/4 turn in either direction.
b Remove the cover. This exposes a gear that controls the height of the print cartridge
cradle.
c Rotate the gear toward the back of the unit until it stops.
Note You will rotate the gear a number of times before it stops.
User Guide 209
Get HP support
212


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP Photosmart 2700 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP Photosmart 2700 series in the language / languages: English as an attachment in your email.

The manual is 5,93 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of HP Photosmart 2700 series

HP Photosmart 2700 series User Manual - German - 249 pages

HP Photosmart 2700 series Installation Guide - Dutch - 16 pages

HP Photosmart 2700 series User Manual - Dutch - 239 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info