724182

HP OfficeJet Pro 9010 series Manual

179
Zoom out
Zoom in
Previous page
1/216
Next page
● If you have a computer dial-up modem on the same phone line with the printer, check to make sure that
the software that came with your modem is not set to receive faxes automatically. Modems that are set
up to receive faxes automatically take over the phone line to receive all incoming faxes, which prevents
the printer from receiving fax calls.
● If you have an answering machine on the same phone line with the printer, you might have one of the
following problems:
– Your answering machine might not be set up correctly with the printer.
– Your outgoing message might be too long or too loud to allow the printer to detect fax tones, and
the sending fax machine might disconnect.
– Your answering machine might not have enough quiet time after your outgoing message to allow
the printer to detect fax tones. This problem is most common with digital answering machines.
The following actions might help to solve these problems:
– When you have an answering machine on the same phone line you use for fax calls, try connecting
the answering machine directly to the printer.
– Make sure the printer is set to receive faxes automatically.
– Make sure the Rings to Answer setting is set to a greater number of rings than the answering
machine.
– Disconnect the answering machine and then try receiving a fax. If faxing is successful without the
answering machine, the answering machine might be causing the problem.
– Reconnect the answering machine and record your outgoing message again. Record a message
that is approximately 10 seconds in duration. Speak slowly and at a low volume when recording
your message. Leave at least 5 seconds of silence at the end of the voice message. There should be
no background noise when recording this silent time. Try to receive a fax again.
NOTE: Some digital answering machines might not retain the recorded silence at the end of your
outgoing message. Play back your outgoing message to check.
● If the printer shares the same phone line with other types of phone equipment, such as an answering
machine, a computer dial-up modem, or a multi-port switch box, the fax signal level might be reduced.
The signal level can also be reduced if you use a splitter or connect extra cables to extend the length of
your phone. A reduced fax signal can cause problems during fax reception.
To nd out if other equipment is causing a problem, disconnect everything except the printer from the
phone line, and then try to receive a fax. If you can receive faxes successfully without the other
equipment, one or more pieces of the other equipment is causing problems; try adding them back one at
a time and receiving a fax each time, until you identify which equipment is causing the problem.
● If you have a special ring pattern for your fax phone number (using a distinctive ring service through
your telephone company), make sure that the Distinctive Ring feature on the printer is set to match.
The printer cannot send faxes, but can receive faxes
● The printer might be dialing too fast or too soon. You might need to insert some pauses in the number
sequence. For example, if you need to access an outside line before dialing the phone number, insert
a pause following the access number. If your number is 95555555, and 9 accesses an outside line, you
might insert pauses as follows: 9-555-5555. To enter a pause in the fax number you are typing, touch
the * repeatedly, until a dash (-) appears on the display.
ENWW Get help in this guide 173
… 179 …


Need help? Post your question in this forum.

Forumrules
1

Forum

hp-officejet-pro-9010-series

Reset search

  • Every time scam or junk calls my fax number, as soon as they hear the fax machine emit its tone They hang up The problem is that every time they do that, my machines types up a report and at the end says, NO FAX.
    That’s very obvious but I’m end a with a pile of useless paper and now the ink is very low from doing it. I would like to stop the Report that it useless and only use them when it is a ligimit fax report. I have an HP office jet 9010 All in one Submitted on 16-5-2022 at 00:10

    Reply Report abuse

  • What is that behind the two covered ports/panels on the back of the printer? Submitted on 1-9-2021 at 17:18

    Reply Report abuse

  • What is behind the two covered ports/panels on the back of the printer? Submitted on 1-9-2021 at 17:14

    Reply Report abuse

  • Miten saan asetettua värikasetit? Yritän asettaa, mutta erittäin tiukka, ei mene paikoilleen. Submitted on 24-7-2021 at 14:44

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP OfficeJet Pro 9010 series at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP OfficeJet Pro 9010 series in the language / languages: English as an attachment in your email.

The manual is 3,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of HP OfficeJet Pro 9010 series

HP OfficeJet Pro 9010 series User Manual - German - 229 pages

HP OfficeJet Pro 9010 series User Manual - Dutch - 223 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info