584662

HP Officejet Pro 8630 Manual

161
Zoom out
Zoom in
Previous page
1/268
Next page
●
Make sure you have correctly connected the printer to the telephone wall jack. Using the phone
cord supplied in the box with the printer, connect one end to your telephone wall jack, then
connect the other end to the port labeled 1-LINE on the back of the printer.
●
Other equipment, which uses the same phone line as the printer, might be causing the test to
fail. To find out if other equipment is causing a problem, disconnect everything from the phone
line, and then run the test again.
◦
If the Fax Line Condition Test passes without the other equipment, then one or more pieces
of the equipment is causing problems; try adding them back one at a time and rerunning
the test each time, until you identify which piece of equipment is causing the problem.
◦
If the Fax Line Condition Test fails without the other equipment, connect the printer to
a working phone line and continue reviewing the troubleshooting information in this section.
●
If you are using a phone splitter, this can cause faxing problems. (A splitter is a two-cord
connector that plugs into a telephone wall jack.) Try removing the splitter and connecting the
printer directly to the telephone wall jack.
●
Make sure you use the phone cord that came with the printer. If you do not use the supplied
phone cord to connect from the telephone wall jack to the printer, you might not be able to send
or receive faxes. After you plug in the phone cord that came with the printer, run the fax test
again.
After you resolve any problems found, run the fax test again to make sure it passes and the printer is
ready for faxing. If the Fax Line Condition test continues to fail and you experience problems faxing,
contact your telephone company and have them check the phone line.
The display always shows Phone Off Hook
●
You are using the wrong type of phone cord. Make sure you are using the 2-wire phone cord
that came with the printer to connect the printer to your phone line. If the phone cord that came
with the printer is not long enough, you can use a longer phone cord to extend the length. You
can purchase the cord at an electronics store that carries phone accessories.
●
Other equipment that uses the same phone line as the printer might be in use. Make sure
extension phones (phones on the same phone line, but not connected to the printer) or other
equipment are not in use or off the hook. For example, you cannot use the printer for faxing if an
extension phone is off the hook, or if you are using a computer dial-up modem to send email or
access the Internet.
The printer is having problems sending and receiving faxes
●
Make sure the printer is turned on. Look at the display on the printer. If the display is blank and
(the Power button) light is not lit, the printer is turned off. Make sure the power cord is firmly
connected to the printer and plugged into a power outlet. Press
(the Power button) to turn on
the printer.
After turning on the printer, HP recommends you wait five minutes before sending or receiving
a fax. The printer cannot send or receive faxes while it is initializing after being turned on.
●
If HP Digital Fax has been enabled, you might not be able to send or receive faxes if the fax
memory is full (limited by printer memory).
ENWW Solve fax problems 145
… 161 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for HP Officejet Pro 8630 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of HP Officejet Pro 8630 in the language / languages: English as an attachment in your email.

The manual is 8,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of HP Officejet Pro 8630

HP Officejet Pro 8630 User Manual - German - 286 pages

HP Officejet Pro 8630 User Manual - Dutch - 276 pages

HP Officejet Pro 8630 Quick start guide - All languages - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info