661668
4
Zoom out
Zoom in
Previous page
1/40
Next page
Warning : Read this manual carefully before
installing this pump.
This sign warns the user that failure to
follow an instruction may damage the
pump or the system
This sign warns the user of important
electrical safety information.
Carefully store this manual.
If problems arise contact
Hozelock customer services.
Every Hozelock Flood Pump
is carefully tested and packed during assembly.
On receipt, check that the pump has not been
damaged during transport. If the pump is
damaged, do not use, and contact Hozelock
customer services.
Check that the voltage and frequency of pump
shown on the rating label corresponds to those
available on the mains.
ELECTRICAL INSTALLATION:
A 10MA OR 30MA RESIDUAL CURRENT
DEVICE (RCD) MUST BE FITTED TO THE
MAINS SUPPLY.
PROTECT THE PLUG AND THE POWER
CABLE FROM HEAT,
OIL AND SHARP EDGES.
DO NOT OPERATE THE PUMP IF IT HAS A
DAMAGED POWER CORD OR PLUG. IF THE
POWER CORD OR PLUG IS DAMAGED, IT
MUST BE REPLACED BY A SUITABLY
QUALIFIED PERSON IN ORDER TO AVOID A
HAZARD.
MAKE SURE THAT ELECTRIC CONNECTIONS
ARE PROTECTED FROM WATER & SPLASHES
THE POWER CABLE SHOULD HAVE A
MINIMUM OF 3 CORE 0.75MM
2
SECTION
EQUIVALENT TO THAT OF H05 RN-F. TO
MAKE SURE THE PLUG IS PROTECTED
FROM ANY SPLASHES, USE THE 10M CABLE
SUPPLIED TO CONNECT AS FAR AWAY
FROM THE PUMP AS POSSIBLE
BEFORE USING THE PUMP, ALWAYS
INSPECT IT VISUALLY (ESPECIALLY THE
POWER CABLE AND THE PLUG). DO NOT
USE THE PUMP IF IT IS DAMAGED.
NEVER USE THE POWER CABLE TO LIFT THE
PUMP.
The pump can be completely or partially
submersed and used to transfer clean or dirty
fluids.
This pump should not be used with
swimming pools where people can become
immersed in water.
This pump shouldnot be used for table
fountains / aquariums / fountains / filters
for fish ponds / waterfalls.
If aquatic wildlife eg fish or frogs could be
present in the water, you must take the
required measure to prevent them being
sucked into the pump.
The pump cannot be used for sea water &
inflammable, corrosive, explosive or
dangerous liquids.
The pump must never run dry.
The pump can handle max solids of 30mm.
However this will be reduced by the
diameter of the hose. eg 25mm hose may
block if solids greater than 25mm are
present.
When set up for automatic operation the
pump will turn on at a water depth of
400mm, and turn off at a water depth of
190mm (Fig 1).
The pump must not be used when people
are in the water.
The sprayer must not be used when people
are in the water.
Do not spray the outlet towards people or
animals.
This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless
they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
Before installation, and whenever you are
Limitations
Electrical Safety
General Safety
Installation
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hozelock 7825 Flood Pump at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hozelock 7825 Flood Pump in the language / languages: All languages as an attachment in your email.

The manual is 4,87 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info