Manual Hotpoint-Ariston LD 6090 EU (page 19 of 80) (English, German, Dutch, French, Italian, Spanish)

513353

Zoom out

Zoom in

1/80

Start-up and use

* Only available in selected models.

Starting the dishwasher

1. Turn the water tap on.

2. Press the STANDBY button: the display will light up.

3. Open the door and pour in a suitable amount of

detergent (

see below

4. Load the racks (

see Loading the racks

) and shut

the door.

5. Select a wash cycle by pressing the SELECT

WASH CYCLE button repeatedly until the number

corresponding to the desired cycle appears (

see

Table of Wash Cycles

6. Select the wash options (

see below

7. Start the cycle by pressing the START/RESET

button: the machine will emit a confirmation beep.

The WASH CYCLE PHASE indicator lights display

the status of the cycle:

Pre-wash, Wash, Rinse, or Drying.

8. At the end of the wash cycle, you will hear two

short beeps and the word “END” will appear on the

display.

9. Switch off the appliance by pressing the

STANDBY button, shut off the water tap and unplug

the appliance from the electricity socket.

10. Open the door and wait for a few minutes before

removing the crockery inside, in order to avoid burns.

Unload the racks, beginning with the lower level.

Demo*

If dON appears on the display, this means that the

appliance is in demonstration mode. To deactivate

it, press the START/RESET and STANDBY buttons

simultaneously: dOF should appear on the display.

Modifying a wash cycle in progress

If a mistake was made during the wash cycle selection

process it is possible to change the cycle, provided

that it has only just begun: press and hold the START/

RESET button for 4 seconds. After one long beep and

three short beeps, the WASH CYCLE PHASE indicator

light will switch off: Select the new cycle and switch the

machine back on by pressing the START/RESET button.

Adding extra crockery

Press the STANDBY button and open the door,

taking care to avoid the escaping steam, and place

the crockery inside the dishwasher. Press the

STANDBY button again: the cycle starts from the

point at which it was interrupted.

Accidental interruptions

If the door is opened during the wash cycle (the text

DOOR will appear on the display), or if there is a

power cut, the cycle stops. It starts again from the

point at which it was interrupted once the door has

been shut or the electricity supply is restored.

Loading the detergent

A successful wash also depends on the correct

amount of detergent being used, as recommended

by the manufacturer. Exceeding the recommended

amount does not result in a more effective wash and

pollutes the environment.

compartment A: Washing detergent

compartment B: Pre-wash detergent

1. Open cover C by

pressing button D.

2. Pour in the detergent

after consulting the

Wash

cycle table

• for powder detergent

use compartments A

and B

• for tablets, use

compartment A and the

bottom of the appliance,

i.e. when the cycle

requires 1 tablet, place it in compartment A and

close the cover; when it requires 2, place the

second tablet at the bottom of the appliance.

3. Remove detergent residues from the edges of the

compartment and close the cover until it clicks.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston LD 6090 EU in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 4,56 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hotpoint-Ariston LD 6090 EU Manual

Product: