Manual Hot Spring JETSETTER - JJ (page 5 of 48) (English)

624654

Zoom out

Zoom in

1/48

Page 2

Safety Information

DANGER - RISK OF ELECTRICAL SHOCK

• Install at least 5 feet (1.5 m) from all metal surfaces. A spa may

be installed within 5 feet of a metal surface if each metal surface is

permanently connected by a minimum No. 8 AWG (8.4 mm

) solid

copper conductor attached to the wire ground connector on the

terminal box that is provided for this purpose if in accordance with

National Electrical Code ANSI/NMFPA70-1993.

• Do not permit any electrical appliances, such as a light, telephone,

radio, or television within 5 feet (1.5 m) of a spa. Failure to maintain

a safe distance may result in death, or serious personal injury due to

electrocution, if the appliance should fall into the spa.

• Install your spa is such a way that drainage is away from the electrical

compartment and from all electrical components.

DO:

• Be sure your spa is connected to the power supply correctly - use a

licensed electrical contractor.

• Disconnect the spa from the power supply before draining the spa or

servicing the electrical components.

• Test the Ground Fault Circuit Interrupter(s) before each use.

• Replace audio components only with identical components (if your spa

is equipped with an audio component).

DON'T:

• Use the spa with the equipment compartment door removed.

• Place electrical appliances within 5 feet (1.5m) of the spa.

• Use an extension cord to connect the spa to its power source. The

cord may not be properly grounded and the connection is a shock

hazard. An extension cord may cause a voltage drop, which will cause

overheating of the jet pump motor and motor damage.

• Attempt to open the electrical control box. There are no user serviceable

parts inside.

RISKS TO AVOID

DANGER - RISK OF INJURY

• To reduce the risk of injury to persons, DO NOT remove suction fittings

(filter standpipes) located in the filter compartment.

• The suction fittings in the spa are sized to match the specific water

flow created by the pump. Never replace a suction fitting with one

rated less than the flow rate marked on the original suction fitting.

• There is a danger of slipping and falling. Remember that wet surfaces

can be very slippery. Take care when entering or exiting the spa.

• Never operate spa if the suction fittings are broken or missing.

• People with infectious diseases should not use the spa.

• Keep any loose articles of clothing, long hair, or hanging jewelry away

from rotating jets or other moving components.

INCREASED SIDE EFFECTS OF MEDICATION

• The use of drugs, alcohol may cause unconsciousness with the

possibility of drowning.

• Persons using medications should consult a physician before using

a spa; some medication may cause a user to become drowsy, while

other medication may affect heart rate, blood pressure, and circulation.

• Persons taking medications which induce drowsiness, such as

tranquilizers, antihistamines, or anticoagulants should not use the spa.

HEALTH PROBLEMS AFFECTED BY SPA USE

• Pregnant women should consult a physician before using spa.

• Persons suffering from obesity, or with a medical history of heart

disease, low or high blood pressure, circulatory system problems, or

diabetes should consult a physician before using spa.

UNCLEAN WATER

• Keep the water clean and sanitized with correct chemical care. The

recommended levels for your HOT SPRING spa are:

Free Available Chlorine:

3.0-5.0 ppm

Total Alkalinity:

40-120 ppm

Water pH:

7.2-7.6

Calcium Hardness:

50-150 ppm

• Refer to Water Quality and Maintenance section for complete

instructions.

IMPORTANT: Turn on the jet pump for a least ten minutes after adding

ANY spa water chemicals into the filter compartment.

Clean the filter cartridges monthly to remove debris and mineral buildup

which may affect the performance of the hydromassage jets, limit the

flow, or trip the high limit thermostat, which will turn off the entire spa.

AVOIDING THE RISK OF HYPERTHERMIA

Prolonged immersion in hot water can result in HYPERTHERMIA, a

dangerous condition which occurs when the internal temperature of

the body reaches a level above normal 98.6°F (37°C). The symptoms

of hyperthermia include unawareness of impending hazard, failure to

perceive heat, failure to recognize the need to exit the spa, physical

inability to exit the spa, fetal damage in pregnant women, and

unconsciousness resulting in a danger of drowning.

WARNING

The use of alcohol, drugs, or medication can greatly increase the risk of

fatal hyperthermia in hot tubs and spas.

TO REDUCE THE RISK OF INJURY

• The water in the spa should never exceed 104°F (40°C). Water

temperatures between 100°F and 104°F (36°C and 40°C) are

considered safe for a healthy adult. Lower water temperatures are

recommended for extended use (exceeding ten minutes) and for

young children. Extended use can cause hyperthermia.

• Pregnant or possibly pregnant women should limit spa water

temperatures to 100°F (36°C). Failure to do so may result in

permanent injury to your baby.

• Do not use spa immediately following strenuous exercise.

I apologise, but it not absolutely approaches me.
Submitted on 27-10-2022 at 01:49
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hot Spring JETSETTER - JJ in the language / languages: English as an attachment in your email.

The manual is 6,11 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hot Spring JETSETTER - JJ Manual

Product: