606949
45
Zoom out
Zoom in
Previous page
1/50
Next page
45SPEKTRUM DX7 • TRANSMITTER INSTRUCTION MANUAL
EN
Adjusting the Throttle Ratchet Strap
The user can loosen the friction strap screw and tighten the
ratchet screw if desired by pulling the top of the grip through the
throttle adjustment opening.
No installation required, no need to remove the case back.
You can adjust the Throttle Ratchet Strap to use either a smooth
throttle or ratchet throttle.
To adjust the Throttle Ratchet Strap:
1. Remove the rubber plugs from the holes on the back of the
transmitter.
2. Using a #0 Phillips screwdriver, loosen or tighten the Throttle
Ratchet Strap screw to adjust the ratchet to your liking.
3. Re-install the plug.
Control Stick Length Adjustment
To adjust the Control Stick Length:
1. Using a 2mm Allen wrench, turn the setscrew in the stick
counterclockwise to loosen it.
2. Make the stick shorter by turning it clockwise or longer
by turn ing it counterclockwise.
3. After adjustment of stick length, tighten the setscrew.
Adjust Stick Tension
Adjust stick tension using the screws on the stick gimbals through
holes in the back of the transmitter.
1. Pull up the top of the rear grip on the back of the transmitter to
adjust the stick gimbal tension. Only the top of the grip must
be pulled up to access the adjustment screw. The entire grip
does not need to be removed.
2. Turn the screws in these holes marked with a vertical or hori-
zontal arrow a small amount using a small Phillips screwdriver.
NOTICE: Always do a test of stick tension while turning these
screws to ensure stick tension is not too loose or too tight.
Tightening a screw too much can damage a spring. Loosening a
screw too much can let a spring fall off and cause short-circuit
in the transmitter.
CAUTION: Always power off the transmitter, disconnect and
remove the battery before adjusting stick tension or friction
straps. Not doing so could result in property damage or injury.
Adjust Throttle Friction Straps
To adjust Throttle Friction:
1. Remove rubber plugs from holes on the back of the transmitter.
2. Use a small Phillips screwdriver to tighten or loosen the screw
for the friction strip.
3. Reinstall the plug after completing the adjustment as desired.
CAUTION: Always power off the transmitter, disconnect and
remove the battery before adjusting stick tension or friction
straps. Not doing so could result in property damage or injury.
Function
1
Gimbal spring access
2
Throttle friction strip tension cover
3
Mode change access
1
1
2
3
PHYSICAL TRANSMITTER ADJUSTMENTS
45


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Horizon Hobby DX7 - 7 Channel DSMX Transmitter at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Horizon Hobby DX7 - 7 Channel DSMX Transmitter in the language / languages: English as an attachment in your email.

The manual is 4,23 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Horizon Hobby DX7 - 7 Channel DSMX Transmitter

Horizon Hobby DX7 - 7 Channel DSMX Transmitter User Manual - German - 49 pages

Horizon Hobby DX7 - 7 Channel DSMX Transmitter User Manual - French - 50 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info