594435

Hoover SteamVac Manual

14
Zoom out
Zoom in
Previous page
1/63
Next page
14
All tools connect to the hose in the same manner.
4.7 Attach tool to connector end of hose by sliding it
onto connector until the tab (I) locks it securely.
Using your thumb, push forward and up on the latch
(J) to remove tool as shown.
I
4.7
HOW TO ATTACH TOOL
BEFORE USING TOOL
It may be necessary to remove air from the system
(“prime the pump”) so the clean solution will flow to
the tool. Follow these steps:
1. Attach tool to hose and turn the carpet cleaner ON.
2. Put the tool on a hard surface or against your
hand to block off the suction.
3. Wait a few seconds (can take up to 15 seconds).
Then squeeze the trigger and begin cleaning.
4.8
J
Place handle in upright position. Agitator brushes
will not rotate while handle is in upright position.
Fill Clean Water Solution Tank with HOOVER
®
Detergent according to instructions on pages 8.
Attach tool to end of hose.
Hose length may require that machine be placed at
the top of the stairs to clean upper half of stairway
and at bottom of stairs to clean lower half.
To prevent machine from falling, use extra caution
when cleaning on stairs.
IMPORTANT
Do not place carpet cleaner on stairs.
Do not point tools toward people or pets.
Dry hands and plug carpet cleaner into a properly
grounded outlet.
Turn carpet cleaner ON. If necessary, refer to
“Before Using Tool” section to remove air from
system.
4.8 Pre-spray the carpeted stair by holding the tool
(A or B in Fig. 4.1) about one inch above the carpet
and push it forward while pressing the trigger
(equals one wet stroke).
CAUTION
! !
To reduce the risk of injury from moving parts,
unplug cleaner.
4.9
4.9 Position tool against the riser and slightly press
it into carpet pile. Press the trigger and pull the tool
slowly over the carpet (second wet stroke). Release
trigger at end of stroke.
Lift tool, and position it against riser. Pull tool slowly
over carpet without pressing trigger (dry stroke).
It is best to alternate wet and dry strokes as
described above. End with more dry strokes to aid
in faster drying of carpet.
Overlap strokes by 1/2 inch to help prevent
streaking.
To avoid saturating carpet, do not use more than 4
wet strokes over any one area. Always end with dry
strokes.
If additional cleaning is necessary, wait until the
carpet is completely dry before using the tool again.
Actual model may vary from images shown.
(Available on select models only)
(Available on select models only)
CLEANING CARPETED STAIRS
(Tool available on select models only)
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hoover SteamVac at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hoover SteamVac in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 2,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info