32665
6
Zoom out
Zoom in
Previous page
1/72
Next page
4
5
Remove Old Thermostat
not
compatible with such systems so return
the product to the place of purchase. If you
would like information about which program-
mable thermostats will work with your system,
call Honeywell Customer Assistance at
1-800-468-1502.
Three thermostat wires?
If you have three wires for heating only and
can operate the fan using the fan ON switch,
this thermostat will work with your system.
However, some hot water (zoned) heating
systems have three thermostat wires. The
thermostat will not work without installing an
isolating relay on these systems. Call Honey-
well Customer Assistance at 1-800-468-1502
for details.
Test to make certain that your heating
and cooling systems are working properly. If
either does not work, contact your local heating/
air conditioning dealer. To avoid compressor
damage, do not operate the cooling system
when outdoor temperature is below 10° C [50°
F].
TURN OFF POWER to system at the
furnace, or at the fuse/circuit breaker panel.
Carefully unpack your new thermostat and
mounting plate; save package of screws,
instructions and receipt.
Remove cover from old thermostat. If it does
not snap off when pulled firmly from the bottom,
check for a screw used to lock on the cover.
Loosen screws holding thermostat to
subbase, wallplate or wall, and lift away.
Disconnect wires from old thermostat or
subbase. As you disconnect each wire, use
masking tape to label it with the old terminal
designation. If there are only two wires, they do
not need to be labeled. Keep the wires from
falling back into the wall by wrapping them
around a pencil, as shown.
STEP 2
WIRES THROUGH
WALL OPENING
M5136
One or two extra wires?
If you are replacing a Honeywell
Chronotherm thermostat, you may find one
or two wires that go to the C or C1 clock
terminals on the Chronotherm thermostat wiring
wallplate. Do not allow them to touch,
or you may damage your transformer. Discon-
nect the wires and wrap them separately, using
electrical tape.
Do not wrap them together
.
Place the wires where they will not interfere with
the operation of the new thermostat. Record the
colors and terminal designation labels of the
remaining wires.
Six or more wires?
If there are six or more wires (excluding
clock wires attached to terminals), you
most likely have a variation of a heat pump
or multistage system. The thermostat is
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honeywell T8132 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell T8132 in the language / languages: English, French as an attachment in your email.

The manual is 0,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info