471572

Honeywell CM721 Manual

10
Zoom out
Zoom in
Previous page
1/12
Next page
10 CM700 Wireless - Programmable Room Thermostat
4.5.2 Category 2 - System Settings
5) Additional Installation Information
5.1 Binding / Rebinding Procedure
The binding operation described below is required if:
• Anyofthesystemcomponents(roomthermostatorrelaybox)arereplaced.
• Therelayboxhasincorrectornobindingdatastored(e.g.whenpre-boundsystempackcomponents
have been mismatched).
NOTE: During the binding procedure keep approximately 1m distance between the room thermostat and
the relay box.
To bind/rebind:
1.
Press and hold the relay box push button for 15 seconds to reset any previously stored data. After 15
seconds the red LED will change to flashing 0.1sec on/0.9sec off.
NOTE: After 5 seconds the red LED will start to flash 0.5sec on/0.5sec off, but continue to hold the
button).
2.
Release the push button.
3. Press and hold the relay box push button for 5 seconds to enter the binding mode. The Red LED will
start flashing at 0.5sec on/0.5sec off to confirm the binding mode has been entered.
4. Press the OFF button on the room thermostat. Then press the and buttons together along with
the button. The unit will display InSt and ‘CONTROL BINDING’.
5. Press the green button to send the binding signal out to the relay box. The red LED is switched off
to confirm successful binding operation. If the red LED still flashes push the button again until binding
is successful.
6. Now go to Section 2) Installing the CM700 Wireless System to setup the system.
Note
1) Remember to always press the green button to confirm that you want to store your new Installer Set-
Up setting. To exit the Installer Mode press the AUTO or MAN button.
Parameter Parameter
No.
Factory Default Setting Optional Setting
Category 2 Parameters – System Settings (press the
button to access this category)
Display Description Display Description
Minimum boiler
ON time
1:Ot 1 1 minute minimum
ON time
2 to 5 Selection of 2, 3, 4 or 5 minutes
minimum ON time
Cycle Rate 2:Cr 6 6 cycles per hour
(cph)
3,9 or
12
Selection of 3, 9 or 12 cph
Pump Exercise 5:PE 0 Pump exercise
disabled
1 Pump exercise enabled
System
Synchronisation
6:Sn 0 Standard operation
of the Room Unit
1 Room unit configured as
Synchroniser
Loss of
Communications
Instruction
7:LC 0 Relay Off 1 Relay 20% on / 80% off
… 10


Need help? Post your question in this forum.

Forumrules
1

Forum

honeywell-cm721

Reset search

  • Green light on red light flashing box next to boiler why .
    Thank youb Submitted on 6-4-2022 at 21:00

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honeywell CM721 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell CM721 in the language / languages: English as an attachment in your email.

The manual is 0,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honeywell CM721

Honeywell CM721 User Manual - English - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info