625278

Honda WMP20X Manual

5
Zoom out
Zoom in
Previous page
1/100
Next page
5
ENGLISH
OPERATION
PUMP PREPARATION
Before operating the pump for the first time, please review
IMPORTANT SAFETY INFORMATION (page 2) and BEFORE
OPERATION (page 4).
For your safety, avoid starting or operating the engine in an enclosed
area, such as a garage. Your engine’s exhaust contains poisonous
carbon monoxide gas, which can collect rapidly in an enclosed area
and cause illness or death.
Suction Hose Connection
The suction hose [1] must be reinforced with a non-collapsible wall or
wire braided construction to prevent suction hose collapse. Keep the
pump as close to the liquid to be pumped as possible. Avoid bends
and sharp turns. Pump performance is best when the pump is not far
above the liquid level and the hose is kept straight. Self-priming time
is also proportional to the suction hose length. Using a longer suction
hose will increase the self priming time.
The strainer [2] provided with the pump should be threaded onto the
hose coupling and attached to the end of the suction hose with a hose
clamp as shown.
Always install the strainer on the end of the suction hose before
pumping. The strainer will prevent debris from entering the pump that
can cause clogging and impeller or other pump damage.
Discharge Hose Connection
A short, large diameter hose will provide lower fluid friction and
improve pump efficiency. A long or small diameter hose increases
fluid friction and reduces pump output.
Tighten the hose clamp to prevent the hose from disconnecting under
high pressure.
Pump Priming
Remove the priming filler cap [1] and completely fill the pump
chamber with liquid before starting the engine. Replace the priming
filler cap.
Operating the pump dry will destroy the pump seal.
• Ensure the pump chamber is full of liquid and the suction hose
strainer is submerged in the liquid to be pumped.
• If the unit has been operated dry, stop the engine immediately and
allow the pump to cool before adding priming liquid.
APPROVED LIQUIDS
The following is a list of chemicals that the multi-purpose pump is
capable of pumping. The operator must verify that the liquid that is to
be pumped is on these lists. After each use, drain the pump chamber
into a suitable container and flush with fresh water.
DO NOT USE FOR PUMPING LIQUIDS FOR HUMAN
CONSUMPTION.
[1]
[2]
WARNING
Chemicals can cause burns or serious injury.
Wear protective clothing and eye protection when handling
chemicals.
Follow the chemical manufacturer’s handling procedures.
[1]
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda WMP20X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda WMP20X in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 8,69 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info