478016

Honda UMS425E Manual

5
Zoom out
Zoom in
Previous page
1/64
Next page
5 EN
FILLING THE OIL TANK
The engine may be seriously
damaged if it is run with
insufficient oil. Check the oil
level on a flat horizontal surface
with the engine switched off. The
engine's service life may be
shortened if nondetergent oil or
2-stroke engine oil is used.
CHECKING THE OIL
LEVEL
1. Place the engine in a
horizontal position on a
flat surface.
2. Remove the oil filter cap
and check the oil level: oil
must be level with the top
of the oil tank neck [1].
3. If the level is too low, top
up with the recommended
oil to the top of the oil filler
neck. Use Honda 4-stroke
oil or an equivalent engine
oil with high detergent
properties, of prime quality and certified as complying with
American automobile manufacturer standards for SG and SF
classification.
The machine must always be
resting on the ground when starting
up. Make sure that it is stable and
that the cutting attachment is not
touching other objects or the
ground.
BEFORE STARTING UP
Check that the guards are
properly fitted and tightened
and that you have the
necessary protective
equipment such as goggles,
gloves, boots and ear-
defenders.
Check that the cutting
attachment and the grips or
handle are correctly tightened.
Move the machine away from the location where the fuel tank was
filled.
Stand on flat, stable ground. Check that the spark plug cap is in
place.
STARTING AND STOPPING
THE ENGINE
COLD START
The machine is considered to be "cold" if the
engine has not been running for more than 5
minutes in the 10 minutes before starting up.
NOTE:
If the ambient temperature is warm
enough (summer), the engine may start without applying the choke.
START THE ENGINE AS
FOLLOWS:
1. Place the Start/Stop
button [2] in the Start
position.
2. Place the choke lever [3] in
the high position (closed).
3. Press the primer pump button [4] located below the carburettor
several times to prime the engine.
4. Gently pull the recoil starter [5] until you feel resistance.
5. Then pull vigorously until
the engine starts.
6. When the engine has
started, return the choke
lever [2] to the low position.
CAUTION:
• Do not pull the recoil starter
cord all the way out.
• Do not release the recoil starter suddenly so that it strikes the
engine. Return it gently to avoid damaging the starter
mechanism.
NOTE:
Always pull the recoil starter vigorously. If you pull too
gently, sparks may not be produced on the spark plug and the
engine will not start.
Do not place your foot or knee on the transmission tube to hold the
machine, as this could bend the tube, rendering the machine
inoperable.
HOT START
The machine is considered to be
"hot" if the engine has been
running for more than 5 minutes in
the 10 minutes before starting up.
The hot start procedure is the
same as the cold start procedure
except that the choke [6] is not
needed. (The lever must be left in
the low position)
.
Oil tank capacity 0,08 l (80 cc)
Recommended oil SAE 10W30
B3 C12
SAFETY
[1]
C7 C9 C10
SAFETY
C1
B1 B2 B5A4
C10
SAFETY
C9
C7C1
[2]
[4]
[3]
[5]
[6]
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda UMS425E at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda UMS425E in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 15,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info