552645

Honda NC 700 Manual

758
Zoom out
Zoom in
Previous page
1/773
Next page
23-3
dummyheaddummyhead
IMMOBILIZER SYSTEM (HISS)
SERVICE INFORMATION
GENERAL
• When checking the immobilizer system (HISS), follow the steps in the troubleshooting flow chart (page 23-8).
• Keep the immobilizer key away from the other vehicle's immobilizer key when using it. The jamming of the key code signal may
occur and the proper operation of the system will be obstructed.
• The key has built-in electronic part (transponder). Do not drop and strike the key against a hard material object, and do not leave
the key on the dashboard in the car, etc. where the temperature will rise. Do not leave the key in the water for a prolonged time
such as by washing the clothes.
• The ECM/PCM as well as the transponder keys must be replaced if all transponder keys have been lost.
• The system does not function with a duplicated key code is registered into the transponder with the immobilizer system (HISS).
• The ECM/PCM can store up to four key codes. (The four keys can be registered.)
• Do not modify the immobilizer system as it can cause the system failure. (The engine cannot be started.)
• For ignition system inspection (page 5-6).
• For ignition switch servicing (page 22-24).
• For engine stop switch inspection (page 22-25).
• For bank angle sensor inspection (page 4-65).
• The following color codes are used throughout this section.
KEY REGISTRATION PROCEDURES
When the key has been lost, or additional spare key is required:
1. Obtain a new transponder key.
2. Grind the key in accordance with the shape of the original key.
3. Apply 12 V battery voltage to the CKP sensor lines of the ECM/PCM using the special tool (page 23-6).
4. Turn the ignition switch ON with the original key and engine stop switch " ". The HISS indicator comes on and it remains on.
• The code of the original key recognized by the ECM/PCM.
• If there is any problem in the immobilizer system (HISS), the system will enter the diagnostic mode and the indicator will remain
on for approx. ten seconds, then it will indicate the diagnostic code (page 23-7).
5. Disconnect the red clip of the inspection adaptor from the battery positive (+) terminal for two seconds or more, then connect it
again. The indicator remains on for approx. two seconds, then it blinks four times repeatedly.
• The immobilizer system (HISS) enters the registration mode. Registrations of all key except the original key inserted in the
ignition switch are cancelled. (Registration of the lost key or spare key is cancelled.)
The spare key must be registered again.
6. Turn the ignition switch OFF and remove the key.
7. Turn the ignition switch ON with a new key or the spare key. (Never use the key registered in previous steps.) The indicator
comes on for two seconds then it blinks four times repeatedly.
• The new key or spare key is registered in the ECM/PCM.
• If there is any problem in the registration, the system will enter the diagnostic mode and the indicator will remain for approx. ten
seconds, then it will indicate the diagnostic code (page 23-7).
• Keep the other transponder key away from the immobilizer receiver more than 50 mm (2.0 in).
Bl = Black G = Green P = Pink W = White
Bu = Blue O = Orange R = Red Y = Yellow
ON
OFF
2 sec.
ON
OFF
2 sec.
… 758 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda NC 700 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda NC 700 in the language / languages: English as an attachment in your email.

The manual is 19,62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info