720160

Honda Miimo HRM40 Live Manual

14
Zoom out
Zoom in
Previous page
1/108
Next page
English | 13
Troubleshooting
Problem Possible Cause Corrective Action
The LED on the
docking station
flashes
The perimeter wire is cut, too
long or too short. Wire not
connected and mower not in the
docking station.
Check that the perimeter wire is not interrupted and is
between 20 and 250 meters in length. Then switch power
supply off and then on again.
Follow instructions in Installation Guide to install the
mower.
Excessive vibrations/
noise
Blade bolt loose Tighten blade bolt to torque of 2.5 Nm.
Cutting blade damaged/bent Replace cutting blade (see figure K).
Mower not docking
reliably
Perimeter wire not properly
attached to docking station
Follow instructions in Installation Guide on layout of
perimeter wire.
Perimeter wire close to a
source of interference
Remove any excess (e.g. coiled up) perimeter wire
around the docking station.
Change perimeter wire ID in the menu.
Mower fails to
operate
On/Off switch not turned on Remove mower out of docking station, turn On/Off switch
on and place mower back into docking station (ensure
docking station is on – LED lights up green).
Possible clogging Always turn On/Off switch off first, then check
underneath the mower. Clear out as necessary (always
wear protective gloves).
Battery not fully charged Place mower in the docking station to allow to charge.
Docking station must be on.
Grass too long Mow lawn with conventional lawnmower to its lowest
height-of-cut setting before using the mower.
Battery too hot/cold The mower operates when the battery internal battery
temperature is between 5 °C – 45 °C. Allow mower to
cool down/warm up. If the error occurs frequently, the
docking station should be positioned in the shade.
Mower standing on
lawn with the display
switched off
Operational problems Press confirm button for screen to light up, or place
mower in docking station.
Mower does not
charge
Battery too hot/cold The mower operates when the battery internal
temperature is between 5 °C – 45 °C. Allow mower to
cool down/warm up. If the error occurs frequently, the
docking sta-tion should be positioned in the shade.
Docking station not switched on Switch on power supply to docking station. If docking
station does not start, contact your Authorized Honda
Dealer.
Charging pins corroded Clean the charging pins.
Mower out of
perimeter wire
Perimeter wire on a slope Leave 30 cm between the perimeter wire and the slope
15°/27 %.
Obstacle near perimeter wire Remove obstacle.
… 14 …


Need help? Post your question in this forum.

Forumrules
1

Forum

honda-miimo-hrm40-live

Reset search

  • Hi There.
    My Honda HRM won't pair with the phone and is no responsive. I'm being asked to press the blue button but nothing seems to happen.
    Thanks Submitted on 7-10-2021 at 17:03

    Reply Report abuse

    • Have you turned it on using the black rocker switch at the lower left rear of the machine. Is there anything on the display. The mower does not "pair" with the machine it connects to it via an app which you must download separately. Answered on 11-10-2022 at 08:45

      Vote up Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Miimo HRM40 Live at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Miimo HRM40 Live in the language / languages: English, German, Dutch, French, Italian, Swedish as an attachment in your email.

The manual is 3,97 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info