580806
39
Zoom out
Zoom in
Previous page
1/56
Next page
39
MAINTENANCE
REMOVAL AND FITTING CUTTING BLADE
REMOVING THE BLADE
1. Remove the key from the lawn mower.
2. Place the lawn mower on its right-hand side, with the connector and
circuit breaker facing upwards [A].
3. Loosen the screws [2] on the blade [1] with a 14 mm socket wrench [3].
Use a wooden wedge to prevent the blade turning while you are loosening the screws.
4. Remove the blade from the blade holder [4].
CAUTION:
When the blade needs sharpening, it is advisable to have this done by skilled personnel at a
Honda dealer in order to avoid any weakening or imbalance of the blade and so as to ensure
that you obtain good quality cutting.
SHARPENING
1. The cutting edges of the blade should be sharpened with a grinding wheel. Only the upper
edge must be sharpened. The original bevel must be maintained in order to obtain a very
keen cutting edge. It is advisable to sharpen the two ends equally so as to ensure the blade
is correctly balanced.
2. After sharpening, check the blade balance with a screwdriver as shown in the diagram. If
either of the sides dips slightly below the horizontal position, that side must be sharpened
again.
CAUTION:
Correct balance of the blade is essential to ensure good cutting
performance. Any blade that has been damaged or that is not correctly
balanced must therefore be replaced.
Use a genuine Honda replacement blade only.
GB
D7 C15
D8
ENTRETIEN
MONTAGE ET DÉMONTAGE LAME DE COUPE
DÉMONTAGE
1. brancher la clé de la tondeuse.
2. Mettre la tondeuse sur le côté droit, prise et disjoncteur tournés vers le
haut [A].
3. visser les vis [2] de lame [1] avec une clé à douille de 14 mm [3].
Utiliser un bloc en bois pour empêcher la lame de tourner lors du desserrage des vis.
4. Retirer la lame du porte lame [4].
PRÉCAUTION:
Afin d’éviter l’affaiblissement des lames, de provoquer leur déséquilibre ou d’obtenir une
coupe de mauvaise qualité, il est cependant préférable de confier l’aiguisage de la lame au
personnel compétent d’un concessionnaire Honda.
AFFÛTAGE
1. Affûter les bords tranchants de la lame avec une meuleuse. N’affûter que le bord supérieur.
Conserver le biseau d’origine afin d’avoir une arête coupante très acérée. Il est
recommandé d’aiguiser les deux extrémités de manière égale, afin de maintenir l’équilibre
de la lame.
2. Après l’affûtage, vérifier l’équilibre de la lame en utilisant un tournevis comme illustré. Si l’un
ou l’autre des bords penche légèrement sous l’horizontale, il faut à nouveau aiguiser ce
côté.
PRÉCAUTION :
L’équilibre de la lame est essentiel pour obtenir de bonnes performances de
coupe. Il faut donc changer toute lame qui serait endommagée ou dont
l’équilibre ne peut être rétabli.
N’utiliser qu’une lame de rechange d’origine Honda.
F
D8
D7 C15
SAFETY
SAFETY
Omhre42b_D-GB-F2.fm Page 39 Jeudi, 4. septembre 2003 9:05 09
39


Need help? Post your question in this forum.

Forumrules
1

Forum

honda-hre42b

Reset search

  • Are the batteries still available for this lawn mower. HRE42B
    Please can you give me a price.

    This machine was purchased about 13 years ago.

    Regards Martin Pitts Submitted on 25-3-2017 at 18:28

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRE42B at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRE42B in the language / languages: English, German, French as an attachment in your email.

The manual is 2,67 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda HRE42B

Honda HRE42B User Manual - Dutch, Italian, Spanish - 56 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info