473996
57
Zoom out
Zoom in
Previous page
1/92
Next page
MAINTENANCE
CARBURETTOR ADJUSTMENT
1. Start the engine in the open air and allow it to reach its normal operating
temperature.
2. Place the throttle control lever in SLOWposition .
3. Screw the pilot screw [1] in or out until you reach the highest idle speed. Generally, the correct
setting is found 2 turns out from the fully in position.
4. When the pilot screw is correctly adjusted, turn the throttle stop screw [2] to obtain the
specified idle speed:
HRD535 : 2 100 ± 150 tr/mn HRA536 - HRD536 - HRH536 : 1700 ± 150 tr/mn
ROTOSTOP SAFETY LEVER CLEARANCE
Measure the clearance [3] at the top of the lever [5] by holding the yellow button [4] pressed in.
It must be between 20 and 30 mm (HRD535 - HRD536), 5 and 10 mm (HRA536 - HRH536).
If necessary:
1. Undo the lock nuts [6] with a 10 mm spanner.
2. Move the nuts [6] up or down as necessary.
3. Retighten the lock nuts [6] and recheck the clearance.
4. Start the engine outdoors and engage the blade clutch lever. Check that the blade starts to
rotate when you pull the lever to the rear, and that it stops rapidly when the lever is released.
If the blade does not start to rotate or stop as it should, even when the cable is correctly
adjusted, the system may need to be repaired. Take the mower to an approved HONDA
dealer.
GB
ENTRETIEN
RÉGLAGE DU CARBURATEUR
1. Mettre le moteur en route à lextérieur et attendre quil atteigne sa
température normale de fonctionnement.
2. Placer la manette de commande des gaz en position LENT .
3. Tourner la vis pilote [1] vers lintérieur ou vers lextérieur jusquau réglage qui produit la
rotation au ralenti la plus élevée. Le plus souvent, le réglage correct est denviron 2 tours
vers lextérieur à partir de la position fermée complète.
4. Après avoir réglé correctement la vis pilote, tourner la vis darrêt des gaz [2] pour obtenir la
vitesse de ralenti normale :
HRD535 : 2100 ± 150 tr/mn HRA536 - HRD536 - HRH536 : 1700 ± 150 tr/mn
JEU AU LEVIER DE SÉCURITÉ ROTOSTOP
Mesurer le jeu [3] au sommet du levier [5] en maintenant le bouton jaune [4] enfoncé. Le jeu doit
être compris entre 20 et 30 mm (HRD535 - HRD536), 5 et 10 mm (HRA536 - HRH536).
Le cas échéant :
1. Desserrer les écrous de blocage [6] avec une clé de 10 mm.
2. Déplacer les écrous [6] vers le haut ou vers le bas suivant nécessité.
3. Resserrer les écrous [6] et revérifier le jeu.
4. Démarrer le moteur à lextérieur et engager le levier dembrayage de lame. Vérifier que la lame
se mette en route lorsque vous poussez le levier et sarrête rapidement lorsque vous le relâchez.
Si la lame ne se met pas en route ou ne sarrête pas comme elle le devrait alors que le réglage
du câble est correct, il est possible quune réparation soit nécessaire. Consulter un
concessionnaire agréé HONDA.
F
C1 C12
C16
C1 C12
C16
57
57


Need help? Post your question in this forum.

Forumrules
1

Forum

honda-hrd536

Reset search

  • Hi, can you tell me what the guarantee is on the Honda hrd536 lawnmowers.
    Thank you. Submitted on 15-9-2022 at 14:14

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda HRD536 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda HRD536 in the language / languages: English, German, French as an attachment in your email.

The manual is 2,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda HRD536

Honda HRD536 User Manual - Dutch, Italian, Spanish - 92 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info