13155
12
Zoom out
Zoom in
Previous page
1/54
Next page
−−
ENGLISH
Engine Oil
Storage Precautions
Adding a Gasoline Stabilizer to Extend Fuel Storage Life
Draining the Fuel Tank and Carburetor
FUEL VALVE LEVER
INDEX MARKS
COOLING FAN
FAN COVER
OFF
FUEL VALVE LEVER
GASKET
DRAIN BOLT
CARBURETOR BOWL
ON
12
If possible, avoid storage areas with high humidity, because that
promotes rust and corrosion.
If your engine will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a furnace, water
heater, or clothes dryer. Also avoid any area with a spark-
producing electric motor, or where power tools are operated.
When adding a gasoline stabilizer, fill the fuel tank with fresh
gasoline. If only partially filled, air in the tank will promote fuel
deterioration during storage. If you keep a container of gasoline
for refueling, be sure that it contains only fresh gasoline.
Add gasoline stabilizer following the manufacturer’s instructions.
After adding a gasoline stabilizer, run the engine outdoors for 10
minutes to be sure that treated gasoline has replaced the
untreated gasoline in the carburetor.
Place an approved gasoline container below the carburetor, and
use a funnel to avoid spilling fuel.
Reinstall the spark plug.
Pull the starter rope several times to distribute the oil in the
cylinder.
Pour a tablespoon 5 10 cm
(5 10 cc) of clean engine oil into
the cylinder.
Remove the spark plug (see page ).
Change the engine oil (see page ).
Stop the engine, and move the fuel valve lever to the OFF
position.
Remove the drain bolt and gasket, and drain the carburetor bowl
fuel into an approved gasoline container.
Move the fuel valve lever to the ON position. This will allow the
fuel tank to drain through the carburetor bowl.
After draining the carburetor bowl and fuel tank, install the drain
bolt and gasket and tighten securely.
Pull the starter rope slowly until resistance is felt.
(At this time the index mark on the cooling fan aligns with the
index mark on the fan cover).
This will close the valves so moisture cannot enter the engine
cylinder. Return the starter rope gently.
Unless all fuel has been drained from the fuel tank, leave the fuel
valve lever in the OFF position to reduce the possibility of fuel
leakage.
If equipped with a battery for electric starter types, recharge the
battery once a month while the engine is in storage.
This will help to extend the service life of the battery.
With the engine and exhaust system cool, cover the engine to
keep out dust. A hot engine and exhaust system can ignite or melt
some materials. Do not use sheet plastic as a dust cover. A
nonporous cover will trap moisture around the engine, promoting
rust and corrosion.
Position the equipment so the engine is level. Tilting can cause
fuel or oil leakage.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when handling
fuel.
Stop engine and keep heat, sparks, and flame away.
Handle fuel only outdoors.
Wipe up spills immediately.
1.
1.
2.
3.
4.
5.
6.
1.
2.
3.
3.
2.
4.
9
10
05/04/12 20:12:06 32Z5N600_012
12


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Honda Engines GXV390 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Honda Engines GXV390 in the language / languages: English as an attachment in your email.

The manual is 3,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda Honda Engines GXV390

Honda Honda Engines GXV390 User Manual - German, Dutch, Italian - 54 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info