13155
10
Zoom out
Zoom in
Previous page
1/54
Next page
−−
ENGLISH
SPARK PLUG
Recommended Spark Plugs:
AIR CLEANER
Inspection
Cleaning
0.70 0.80 mm
(0.028 0.031 in)
SEALING
WASHER
SIDE ELECTRODE
AIR CLEANER
BASE
WING NUT
AIR CLEANER
COVER
PAPER AIR
FILTER
ELEMENT
FOAM AIR
FILTER
ELEMENT
SPARK PLUG CAP
SPARK PLUG WRENCH
10
BPR5ES (NGK)
W16EPR-U (DENSO)
The recommended spark plug is the correct heat range for normal
engine operating temperatures.
An incorrect spark plug can cause engine damage.
For good performance, the spark plug must be properly gapped
and free of deposits.
Disconnect the spark plug cap,
and remove any dirt from
around the spark plug area.
Remove the spark plug with a
13/16-inch spark plug wrench.
Inspect the spark plug.
Replace it if damaged, badly
fouled, if the sealing washer
is in poor condition, or if the
electrode is worn.
The gap should be:
0.70 0.80 mm (0.028 0.031 in)
Measure the spark plug
electrode gap with a wire-
type feeler gauge. Correct the
gap, if necessary, by carefully
bending the side electrode.
Install the spark plug carefully,
by hand, to avoid cross-
threading.
After the spark plug is seated, tighten with a 13/16-inch spark
plug wrench to compress the sealing washer.
When reinstalling the original spark plug, tighten 1/8 1/4 turn
after the spark plug seats to compress the washer.
When installing a new spark plug, tighten 1/2 turn after the spark
plug seats to compress the washer.
A loose spark plug can overheat and damage the engine.
Overtightening the spark plug can damage the threads in the
cylinder head.
Attach the spark plug cap to the spark plug.
A dirty air cleaner will restrict air flow to the carburetor, reducing
engine performance. If you operate the engine in very dusty areas,
clean the air filter more often than specified in the MAINTENANCE
SCHEDULE.
Operating the engine without an air filter, or with a damaged air
filter, will allow dirt to enter the engine, causing rapid engine wear.
This type of damage is not covered by the
Distributor’s Limited
Warranty.
Remove the wing nut from
the air cleaner cover, and
remove the cover.
Inspect both air filter
elements, and replace them if
they are damaged. Always
replace the paper air filter
element at the scheduled
interval (see page ).
Clean the air filter elements if they are to be reused.
Paper air filter element: Tap the filter element several times on a
hard surface to remove dirt, or blow compressed air [not
exceeding 207 kPa (2.1 kgf/cm
, 30 psi)] through the filter
element from the inside. Never try to brush off dirt; brushing will
force dirt into the fibers.
Foam air filter element: Clean in warm soapy water, rinse, and
allow to dry thoroughly. Or clean in nonflammable solvent and
allow to dry. Dip the filter element in clean engine oil, then
squeeze out all excess oil. The engine will smoke when started if
too much oil is left in the foam.
Wipe dirt from the inside of the air cleaner base and cover, using
a moist rag. Be careful to prevent dirt from entering the air duct
that leads to the carburetor.
Remove the air cleaner cover and inspect the filter elements.
Clean or replace dirty filter elements. Always replace damaged
filter elements.
Remove the air filter
elements.
Remove the foam air filter
element from the paper air
filter element.
Place the foam air filter element over the paper element, and
reinstall the assembled air filter.
Install the air cleaner cover, and tighten the wing nut securely.
1.
2.
4.
3.
1.
2.
4.
3.
5.
6.
7.
8.
9.
7
5.
8.
7.
6.
05/04/12 20:11:27 32Z5N600_010
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda Honda Engines GXV390 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda Honda Engines GXV390 in the language / languages: English as an attachment in your email.

The manual is 3,83 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Honda Honda Engines GXV390

Honda Honda Engines GXV390 User Manual - German, Dutch, Italian - 54 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info