527019
11
Zoom out
Zoom in
Previous page
1/64
Next page
11
ENGLISH
If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at startup. This is normal.
TRANSPORTING
Keep the engine level when transporting to reduce the possibility of
fuel leakage. Turn the fuel valve to the OFF position.
Review the instructions provided with the equipment powered by this
engine for any procedures that should be followed for transporting.
TAKING CARE OF UNEXPECTED PROBLEMS
Engine will not start
Engine lacks power
TECHNICAL INFORMATION
Serial Number and Type Location
See figure on page 1.
Record the engine serial number and type in the space below. You will
need this information when ordering parts and when making technical
or warranty inquiries.
Carburetor Modifications for High Altitude Operation
At high altitude, the standard carburetor air-fuel mixture will be too
rich. Performance will decrease, and fuel consumption will increase. A
very rich mixture will also foul the spark plug and cause hard starting.
Operation at an altitude that differs from that at which this engine was
certified, for extended periods of time, may increase emissions.
High altitude performance can be improved by specific modifications
to the carburetor. If you always operate your engine at altitudes above
1,500 meters, have your servicing dealer perform this carburetor
modification. This engine, when operated at high altitude with the
carburetor modifications for high altitude use, will meet each emission
standard throughout its useful life.
Even with carburetor modification, engine horsepower will decrease
about 3.5% for each 300-meter increase in altitude. The effect of
altitude on horsepower will be greater than this if no carburetor
modification is made.
NOTICE
When the carburetor has been modified for high altitude operation,
the air-fuel mixture will be too lean for low altitude use. Operation at
altitudes below 1,500 meters with a modified carburetor may cause
the engine to overheat and result in serious engine damage. For use
at low altitudes, have your servicing dealer return the carburetor to
original factory specifications.
Specifications
GCV140
GCV160
POSSIBLE CAUSE CORRECTION
Fuel valve is OFF. Move the fuel valve lever to ON.
Choke is OFF. Unless the engine is warm, move
the choke/throttle lever, choke rod,
or choke lever to the CHOKE
position.
Ignition switch or engine stop
switch is OFF.
Move the flywheel brake lever to
RUN position.
Throttle lever to FAST position.
Engine stop switch to ON.
Out of fuel. Refuel.
Bad fuel; engine stored
without treating petrol, or
refueled with bad petrol.
Refuel with fresh petrol.
Spark plug faulty, fouled, or
improperly gapped.
Adjust or replace the spark plug
(page 9).
Spark plug wet with fuel
(flooded engine).
Dry and reinstall the spark plug.
Start the engine with the
choke/throttle lever in the FAST
position.
Choke in the OFF position.
Fuel filter clogged, carburetor
malfunction, ignition
malfunction, valves stuck, etc.
Take the engine to an authorized
Honda servicing dealer or refer to
the shop manual to replace or
repair faulty components as
necessary.
POSSIBLE CAUSE CORRECTION
Air filter clogged. Clean or replace the air filter
(page 9).
Bad fuel; engine stored
without treating the petrol, of
refueled with bad petrol.
Refuel with fresh petrol.
Fuel filter clogged, carburetor
malfunction, ignition
malfunction, valves stuck, etc.
Take the engine to an authorized
Honda servicing dealer or refer to
the shop manual to replace or
repair faulty components as
necessary.
MODEL SERIAL NUMBER TYPE
GCV140,160,190 __ __ __ __ __– __ __ _ __ __ __ __ _ __
Date of purchase
TYPE RECOIL START
Length x Width x Height 367 x 331 x 360 mm
Dry weight 9.8 kg
Engine type 4-stroke, overhead cam, single cylinder
Displacement [Bore x Stroke] 160 cm
3
[64 x 50 mm]
Oil capacity 0.50 L
Fuel tank capacity 0.91 L
Fuel consumption 1.1 L/h at 3,000 rpm
Cooling system Forced air
Ignition system Transistorized magneto
PTO shaft rotation Counterclockwise
TYPE RECOIL START ELECTRIC START
Length x Width x Height 367 x 331 x 360 mm 367 x 354 x 360 mm
Dry weight 9.8 kg 11.6 kg
Engine type 4-stroke, overhead cam, single cylinder
Displacement [Bore x Stroke] 160 cm
3
[64 x 50 mm]
Oil capacity 0.50 L
Fuel tank capacity 0.91 L
Fuel consumption 1.1 L/h at 3,000 rpm
Cooling system Forced air
Ignition system Transistorized magneto
PTO shaft rotation Counterclockwise
Charging system: BBC types
Flywheel brake types
12 VDC, 0.15 A min. @ 2900 rpm
12 VDC, 0.20 A min. @ 2900 rpm
0039Z0LA400.book Page 11 Wednesday, May 29, 2013 1:19 PM
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Honda GCV140 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Honda GCV140 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 5,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info