630639
14
Zoom out
Zoom in
Previous page
1/40
Next page
Page 10 — English
WARNING:
Do not allow familiarity with tools to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
WARNING:
Do not use any attachments or accessories not recom-
mended by the manufacturer of this tool. The use of at-
tachments or accessories not recommended can result
in serious personal injury.
WARNING:
Do not allow hands, feet, or any other part of the body or
clothing near the rotating tines or any other moving part.
The tines begin to rotate forward once the switch trigger
is depressed. The tines continue to rotate until the switch
trigger is released. Failure to avoid contact could cause
serious personal injury.
APPLICATIONS
Breaking up garden soil to prepare seed bed for planting
Shallow cultivating to remove weeds
STARTING/STOPPING THE CULTIVATOR
See Figures 8 - 9.
Route an approved outdoor extension cord through the
upper extension cord retainer ring.
Tie extension cord to plug connector, see figure 1.
Plug the cultivator into the extension cord.
Stand behind the unit with the tines on the ground and
the work area clean and free of obstructions.
Depress the switch lock-out.
Pull the switch trigger toward the handlebar to begin tine
rotation.
To stop the cultivator, release the switch trigger.
PREPARING THE SEED BED
See Figures 10 - 12.
The cultivator can be used to break up garden soil and pre-
pare a seedbed for planting. Plan ahead to leave enough
room between the seed rows to allow for machine cultivating
after the plants have grown.
With the wheel/drag stake assembly installed in position A
roll the machine to the work area.
For general cultivating, remove or adjust the wheel/drag
stake assembly using the guidelines in Adjusting Wheel
Position.
The wheel/drag stake assembly has three installation
positions to choose from. Based on the type of soil being
cultivated and soil conditions at the time, the appropriate
height of the wheel/drag stake assembly will vary. Adjust
the wheel/drag stake assembly position using the
guidelines in Adjusting cultivator speed and depth.
Route an approved outdoor extension cord through the
upper extension cord retainer ring.
Tie extension cord to plug connector, see figure 1.
Plug the cultivator into the extension cord.
Stand behind the unit with the tines on the ground and
the work area clean and free of obstructions.
Depress the switch lock-out.
Pull the switch trigger toward the handlebar to begin tine
rotation.
NOTE: If the machine moves forward too quickly and
wheels are in position A or B with wheel/drag stake
assembly installed, push down on the handlebar to allow
the tines and/or wheel/drag stake assembly to penetrate
the soil and slow the forward motion of the unit. The
rotating tines help to pull the machine forward, so use
slower speeds and a shallow depth setting when learning
to use the unit and when cultivating on rough or uneven
ground.
NOTE: Several passes over the same path may be required
to reach the desired depth. Do not try to dig too deeply in
the first pass. If the machine jumps or bucks, allow the unit
to move forward at a slightly faster rate or install wheel/drag
stake assembly.
To dig more deeply, lift up on the handlebar. Apply downward
pressure on the handlebar for more shallow cultivating.
If the machine stays and digs in one spot, try rocking the unit
from side to side to start it moving forward again.
If the soil is very hard, water a few days before cultivating.
Avoid working the soil when soggy or wet. Wait a day or two
after heavy rain for the ground to dry.
GENERAL CULTIVATING
See Figure 11.
Shallow cultivating less than 2 in. deep can be used to disrupt
weeds and aerate soil, without injuring nearby plant roots. It
should be done often so that weeds do not grow large and
cause tangling in the tines of the unit.
The two outer tine blades can be removed from the unit to
allow a more narrow cultivating width.
To remove the two outer tines:
Unplug the cultivator.
OPERATION
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Homelite UT46510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Homelite UT46510 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 7,15 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Homelite UT46510

Homelite UT46510 Quick start guide - English, French - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info